500TVE30-2 DeVilbiss Compressor - Overview

Diagrams for 500TVE30-2

See every part. Know exactly what you need.

Page

Parts for the 500TVE30-2

Strip Rubber Foot

Part #SUDL-6-1

Nut .375-16 UNC-2B H

Part #SSF-8080-ZN

Tube Outlet .375OD A

Part #AC-0126

Shroud Rear Twin Cyl

Part #DAC-243

Gauge Right Hand

Part #AC-0009-1

Tube Pres Rel .250OD

Part #AC-0028

$7.44

CUP SADDLE MOUNT

Part #ACG-18

This saddle mount cup is an OEM direct from Craftsman for air compressors. This part holds the screw in place. You will need a wrench to remove the bolts that go through it. It is recommended that you wear gloves when replacing this part. This saddle mount cup is made of steel and sold individually.

$16.13

VALVE SAFETY 150 .12

Part #97503734

This safety valve is a genuine replacement part manufactured for use with air compressors. If the compressor's pressure switch malfunctions and does not turn the motor off when the amount of pressure is met, the safety valve will open to release the extra air pressure. The amount of pressure required to open the safety valve is set by the...Read more

Read less

$7.44

ISOLATOR 3 POINT MOU

Part #ACG-19

$7.44

ASSY FASTENER

Part #ACG-408

This assembly fastener is supplied directly from the original equipment manufacturer. The screws are constructed of metal, and are compatible with many compressor machines. This part is often used to secure the compressor shroud. It is recommended to refer to specific manual and diagrams for repair instructions. This part is sold individu...Read more

Read less

REGULATOR 4PORT P1P2

Part #AC-0007

This is a genuine OEM part that is intended to be used with air compressors from Porter Cable, DeVilbiss, and Black & Decker. The regulator is used to adjust the level of pressure in the tank. This item is sold as an individual replacement part.

NIPPLE 1/4-18 NPT X

Part #SSP-480

Repair Tips From Fixers Like You

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

Can't find this special screw used on many housings etc

4 of 6 people found this instruction helpful.

Tim from Tucson, AZ
Very Easy
15 - 30 mins

Actually don't like using Torx bits because they are hard to center deep in the channel. I had misplaced these forcing me to order replacements.
My plan is to insert Torx bits before screwing in and using jb weld to secure the bit to the screw, giving me a hex head. Can't find this special screw with a hex head. This screw is called ... Read more

Read less

Was this helpful?