41CDZ20C799 Craftsman Trimmer - Overview
Sections of the 41CDZ20C799
[Viewing 1 of 1]
Keep searches simple, eg. "belt" or "pump".
SCREW:10-32X.562:#8P
PartSelect #: PS18442924
Manufacturer #: 1964
This is a genuine OEM sourced replacement housing screw designed for Ryobi and Troy-Bilt trimmers and blowers. It is commonly utilized to secure the starter housing. Please note, this metal housing sc...
No Longer Available
Common Symptoms of the 41CDZ20C799
[Viewing 3 of 3]Will Not Start
Fixed by
these parts
these parts
Show All
Engine stops after a few seconds or minutes
Fixed by
these parts
these parts
Show All
Engine revs but trimmer head will not turn
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Fuel line broke
Removed the two screws holding the fuel tank to the main unit. Removed the two fuel lines and any stuck on rubber. Installed and installed two screws to mount the new tank. Slid fuel lines on their respective connectors. Done.
Parts Used:
-
Erik from ROBERTSDALE, AL
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
13 of 16 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
string trimmer would not start
emptied fuel from tank. pulled off the 2 fuel lines from the carburetor.opened the air cleaner door. removed the 2 torque screws that hold on the carburetor. removed the carburetor and air cleaner gasket. installed new carburetor and gasket and put back and tightened the 2 torque screws. closed air cleaner door and pushed the fuel lines onto the new carburetor.put some fuel in the tank. started the trimmer. runs great.
Parts Used:
-
john from SHARPSVILLE, PA
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
6 of 8 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Replace Starter Housing with broken pull cord.
1. Remove Shaft & clutch cover by removing 3 torx screws and loosening cinch bolt.
2. Remove clutch assembly with torx tool in center and then by cinching the shaft and turning spring assembly counter clockwise with an adjustable wrench.
3. Remove starter housing by removing 3 Torx bolts from the front and a screw from the back.
4 Reverse the process.
2. Remove clutch assembly with torx tool in center and then by cinching the shaft and turning spring assembly counter clockwise with an adjustable wrench.
3. Remove starter housing by removing 3 Torx bolts from the front and a screw from the back.
4 Reverse the process.
Parts Used:
-
Timothy from GAINESBORO, TN
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Wrench (Adjustable)
2 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!