4110C Makita Circular Saw - Overview

Genuine Makita replacement part. This phillips countersunk head screw (also called a flat-head) is sold individually.

This is a high-quality screw that is supplied directly from the original equipment manufacturer for use with Makita power tools. It is a standard hardware which has multiple applications depending on the model of your unit, please make sure to check appropriate diagrams for the correct location and used of this screw. This durable metal pan head screw is sold individually.

Genuine Makita replacement part. rnThis phillips pan-head screw includes a washer. It is sold individually.

This is an authentic Makita replacement part that has been sourced from the original manufacturer to be used with circular saws, table saws, masonry saws, planers, demolition hammers, and angle cutters. The washer has multiple applications based on the model of the power tool. It is recommended to review your model's diagram to verify this washer's compatibility. The washer is sold individually.

This flat washer is a high quality replacement part that is specially produced for use on Makita power tools. It is an authentic OEM sourced hardware that helps to distribute the pressure evenly between the two connected pieces. It has multiple applications depending on the equipment, please refer to appropriate diagrams for correct location and use of this item. One durable metal washer is included per order.

This is a genuine manufacturer-supplied part that is made for Makita power tools. Washers are commonly utilized to provide a tight fit between connected components. Over time the material will wear out and it may begin to fail eventually requiring a replacement. This high-quality washer is made of durable metal and is sold individually. I...Read moret is a standard hardware which may have multiple applications. Refer to the parts diagrams for your model to ensure the correct repair procedure.

This is an OEM part sourced directly from the manufacturer. The stop ring is commonly found in Makita drills, sanders, and planers. This part is made of metal, and is generally used to secure components on a shaft. It may be found in various locations in the machine, depending on model. Please refer to the parts diagram to be sure of ...Read moreordering the correct part. You will require pliers when replacing this item. The stop ring is available as an individual replacement part. Included in Part Number 183564-0

This authentic retaining ring is supplied by the original equipment manufacturer for use with Makita power tools. It is an identical replacement for a damaged or a missing hardware that was installed on a new unit. Check the diagrams for your model to ensure the exact location and the correct application of this part. Keep in mind this hi...Read moregh-quality retaining ring is made of durable metal and is sold individually. You will snap-ring pliers to secure or remove it.

This genuine OEM woodruff key is a small, semicircular metal piece used in various power tools to connect rotating parts, such as shafts or gears, to other components like wheels or pulleys. It prevents slippage between these parts, ensuring smooth synchronization and power transmission. With a width of 3/32 inches and a length of 5/8 inc...Read morehes, consider replacing a woodruff key if you notice misalignment or excessive movement between the connected parts. Be sure to inspect the key for signs of wear, damage, or bending. Removing the key depends on the make and model of your tool. If the key is visible, gently tap it from one side using a small hammer and a punch or drift pin. This will dislodge it from its slot. If the key is stuck or difficult to access, you may need to partially disassemble the tool to gain better access to the key. Once the key is loose, carefully pull it out using pliers. Clean the keyway and slot before installing the new key. Before making your purchase, remember that this component is sold individually.