4100NH3ZX Makita Saw - Overview

Included in Part Number 539168-0

Included in part number 596141-3

Included in part number 182918-8

Included in Part Number 516306-1

This is an authentic Makita replacement part that has been sourced from the original manufacturer to be used with circular saws, table saws, masonry saws, planers, demolition hammers, and angle cutters. The washer has multiple applications based on the model of the power tool. It is recommended to review your model's diagram to verify this washer's compatibility. The washer is sold individually.

This part is made of metal and is available individually. A wrench may be required to replace this part if it becomes broken or stripped. The hex nut fits between the drive gear and the gear housing. This is an authentic Makita replacement part that is sourced from the original manufacturer for use with angle grinders.

This is a Genuine OEM replacement part used on Makita Power Tools. This item is made out of Plastic and it is Sold Individually. The purpose of the Brush Cap is to retain the Brushes in the Brush Holders. This Brush Cap has external threads that thread into the housing of the tool. Be careful when removing and replacing these, they have a tendency to break.

Length 8 Foot Length: 6' Gauge: 18 Wires: 2 Type: Bare Wire This power supply cord is a genuine OEM sourced replacement part. It is specially made to supply power from a standard outlet to Makita power tools. A cracked or damaged cord should be replaced before continuing to use the tool. This rubber insulated cord is sold individ...Read moreually. It comes with a rubber sleeve grommet that is not sold separately. Replacing this power supply cord you will need a screwdriver. • Remove the housing screws • Remove the the housing • Disconnect the old cord wires • Remove the old power cord • Secure the new cord in place • Connect the wires • Reassemble and test the new cord

This is an authentic Makita replacement part, sourced from the original manufacturer for use with power tools. Bearings are used to reduce friction between a rotating shaft and fixed part assembly. This bearing is used with several different types of equipment and the bearing\'s application can vary based on the tool model. The bearing is...Read more sold individually, see illustrated part diagram for the bearings location and usage.

This Ball Bearing is sealed on both sides. This genuine Makita replacement part is sold individually. rnrn • Ball bearings minimize friction between rotating parts in your tool. The balls or rollers bear the load and spin, distributing the weight evenly, while the minimal contact area of the balls reduces friction. This reduces wear on...Read more the tool, allowing it to run smoothly. rn • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.