My Orders
41002 (ABWESEU) LG Washer - Overview
Diagrams for 41002
See every part. Know exactly what you need.
Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".
Search filter:
Clear Filter
Your search term must have 3 or more characters.
$138.95
In Stock
Washing Machine Drain Pump
Part #4681EA2001T
The drain pump and motor assembly may also be known as the washer drain pump and is a part for your washer. The drain pump helps expel water from the washing machine. The drain pump is activated after the spin cycle speed is maintained for a specific period of time. To make this installation you will need a Phillips screwdriver, a small f...Read morelat-blade screwdriver, a pair of needle-nose pliers, and a pair of slip-joint pliers. Note that the pump casing is not included. This medium-difficulty repair may vary, but can generally be started by disconnecting power, then removing the top of the washer by taking out the four back screws and two small brackets. Then, remove the front panel by taking out the two screws and eight tabs that should be taken from the top. Moving down the front of the washer, remove the door, latch, tub gasket, and drain cover. Disconnect the drain hoses and clip from under the drain assembly, and install new assembly from there. Reassemble parts in direct reverse order -- taking photos during disassembly and keeping parts clearly organized can help here. Despite the number of steps, you will only need a standard Phillips screwdriver to complete this repair.
Read less
$67.05
In Stock
Water Inlet Valve - Hot
Part #5220FR2006H
Hot water enters the washer through this single solenoid inlet valve, which opens when the control calls for hot water and closes when filling stops. It connects the household hot water supply to the internal fill system, regulating flow during selected wash cycles. A faulty valve may prevent hot water from entering, cause slow filling, o...Read morer allow water to seep into the tub while the washer is off. Replacing a damaged valve helps restore controlled filling and proper shutoff of the hot water supply. This is an OEM part sourced directly from the manufacturer.
Read less
$67.05
In Stock
Magnetic Door Plunger
Part #AGM73610701
This washer magnetic door plunger holds the door slightly open between loads, allowing air to circulate through the drum and around the door seal. This helps trapped moisture dry and reduces musty odours. The spring lets the plunger press inward when you close the door for a wash cycle. Broken tabs, a damaged spring, or a missing magnet m...Read moreay keep it from holding the door in the vented position. Replacing a damaged plunger restores this handy way to air out the washer after use. This is an OEM part sourced directly from the manufacturer.
Read less
$57.15
In Stock
Shock Absorber Kit
Part #383EER3001J
The suspension shock absorber connects the tub to the cabinet base and resists sudden movement as the load turns. A worn or damaged absorber may allow excessive shaking, thumping, or repeated unbalanced cycle interruptions. Replacing a faulty absorber helps restore controlled tub movement and steadier operation. By limiting tub travel, it...Read more also reduces repeated impacts and movement transferred to the washer cabinet. This is an OEM part sourced directly from the manufacturer.
Read less
$39.55
In Stock
Tub-to-Pump Drain Hose
Part #4738ER1002A
Water leaves the washer tub through this flexible tub-to-pump drain hose before reaching the drain pump housing. Its corrugated bellows section bends with tub movement, helping maintain the connection during washing and spinning. Cracks, punctures, or worn folds may allow water to leak beneath the appliance, while a collapsed section can ...Read morerestrict drainage. Replacing a damaged hose restores the enclosed path between the tub and pump, helping water drain properly while accommodating movement between the suspended tub and the pump assembly. This is an OEM part sourced directly from the manufacturer.
Read less
$26.65
In Stock
$54.95
In Stock
Washer Hinge Spring
Part #4970FR2084Z
This heavy-duty suspension spring fits select front-load washing machines and washer-dryer combinations. It connects the outer tub to the cabinet and helps support the tub while absorbing movement during washing and spinning. Replace the spring if it is stretched, weak, rusty, broken, or no longer holds the tub correctly. Use the exact wa...Read moresher model number to guarantee the proper fit. Check the product listing to confirm the quantity because some washers use more than one spring. Unplug the washer, shut off the water, and support the tub before removing the spring. This is an OEM part sourced directly from the manufacturer.
Read less
$39.07
In Stock
Washer Thermistor
Part #6322FR2046C
Accurate temperature feedback helps the appliance control heating throughout a cycle. This thermistor sensor changes electrical resistance as temperature changes, sending a reading to the main control board so it can manage heat as needed. A damaged or inaccurate sensor may cause incorrect temperatures, interrupted cycles, or a temperatur...Read moree sensing fault message. Replacing a faulty thermistor helps restore reliable feedback and normal heating control. The sensor monitors temperature at its installed location, allowing the control system to respond as conditions change during operation. This is an OEM part sourced directly from the manufacturer.
Read less
$38.27
In Stock
Detergent Dispenser
Part #3891ER2003A
Liquid detergent stays contained in this removable dispenser cup until water flushes it into the washer during the wash cycle. The blue plastic insert sits inside the main detergent drawer and can be lifted out for cleaning. Cracks, damaged edges, or a missing cup may prevent liquid detergent from being held properly before dispensing. Re...Read moreplacing a damaged insert restores the container used for liquid detergent in the dispenser drawer. Its removable design also makes it easier to rinse away residue that collects with regular use. This is an OEM part sourced directly from the manufacturer.
Read less
$41.75
In Stock
Washer Gasket
Part #MDS62058301
Keeping wash water away from the rear tub bearings helps protect smooth drum movement. This washer tub seal fits around the rotating drive shaft, forming a barrier between the water inside the tub and the bearing area. Worn edges, cracks, or hardened rubber may allow water to leak behind the tub and reach the bearings. Replacing a damaged...Read more seal restores that barrier and helps contain water during washing and spinning. Its sealing edge stays in contact with the shaft while allowing it to rotate. This is an OEM part sourced directly from the manufacturer.
Read less
$34.22
In Stock
Pump Filter
Part #383EER2001A
The removable filter and cap assembly provides access for routine cleaning and seals the filter opening when tightened. Cracks, damaged threads, or a worn sealing surface may cause leaks or prevent secure closure. Replacing a damaged assembly restores the debris trap and sealed access point. Regular removal of collected material helps kee...Read morep water moving through the drainage system during wash cycles. This is an OEM part sourced directly from the manufacturer.
Read less
$84.65
In Stock
Washer Switch Assembly
Part #EBF61315802
This door lock switch is a key component in compatible washing machines, designed to signal the control board when the door is securely closed. Once engaged, it enables the locking mechanism and allows the wash cycle to begin safely. Constructed from black, gray, and white plastic, this switch may need replacement if your washer struggles...Read more to start or fails to lock properly. Installation requires partial disassembly of the appliance and basic tools including a screwdriver, drill, and needle-nose pliers. Sold individually.
Read less
Exact Part matches for your search term
No Longer Available
$28.84
Special Order
No Longer Available
Common Symptoms of the 41002
How this model fails, and the parts that fix it.
Will not drain
Fixed by
these parts
these parts
Show All
Leaking
Fixed by
these parts
these parts
Show All
Draining Issues
Fixed by
these parts
these parts
Show All
Lid or door won’t close
Fixed by
these parts
these parts
Show All
Water Filling Issues
Fixed by
these parts
these parts
Show All
Locking Issues
Fixed by
these parts
these parts
Show All
Does not dispense fabric softener or detergent
Fixed by
these parts
these parts
Show All
Will Not Start
Fixed by
these parts
these parts
Show All
Shaking and Moving
Fixed by
these parts
these parts
Show All
Engine runs but does not pump water
Fixed by
these parts
these parts
Show All
No hot or cold water
Fixed by
these parts
these parts
Show All
Noisy
Fixed by
these parts
these parts
Show All
Not draining
Fixed by
these parts
these parts
Show All
Spinning Issues
Fixed by
these parts
these parts
Show All
Watch our pros, then fix it yourself.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!
View More