4014NV Makita Leaf Blower / Vacuum - Overview

This manufacturer sourced replacement pin is made out rubber and it is sold individually. It acts as a cushion/spacer in a variety of Makita power tools. This is a standard piece of hardware and it has multiple applications based on your tool. Please refer to diagrams for correct application.

Manufacturer sourced replacement part designed for use on Makita power tools. The purpose of the brush cap is to hold the brush in the tool. This cap has external threads that thread into the housing of the tool. Be careful when removing and replacing these, they have a tendency to break. This item is made out of plastic and it is sold individually.

Length 8 Foot Length: 6' Gauge: 18 Wires: 2 Type: Bare Wire This power supply cord is a genuine OEM sourced replacement part. It is specially made to supply power from a standard outlet to Makita power tools. A cracked or damaged cord should be replaced before continuing to use the tool. This rubber insulated cord is sold individ...Read moreually. It comes with a rubber sleeve grommet that is not sold separately. Replacing this power supply cord you will need a screwdriver. • Remove the housing screws • Remove the the housing • Disconnect the old cord wires • Remove the old power cord • Secure the new cord in place • Connect the wires • Reassemble and test the new cord

This is an authentic OEM approved replacement item commonly used on Makita power tools. Bearings have many useful applications that will differ depending on a tool. Ball bearings are designed to minimize friction between two rotating parts. Because they are under constant pressure. Over time due to heat and friction bearings would break d...Read moreown and would need to be replaced. Please note this is a sealed metal bearing that is sold individually.

Included in Part Number 516306-1. rnThis Ball Bearing is sealed on both sides. This genuine Makita replacement part is sold individually. rnrn • Ball bearings minimize friction between rotating parts in your tool. The balls or rollers bear the load and spin, distributing the weight evenly, while the minimal contact area of the balls re...Read moreduces friction. This reduces wear on the tool, allowing it to run smoothly. rn • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This cord guard is a genuine Makita replacement part, and it is a direct replacement for a damaged or missing cord guard. Power tool cords undergo a lot of stress, and these cord guards help to alleviate some of that stress at the weakest point--right where the cord enters the tool. Over time cord guards will deteriorate and eventually re...Read morequire replacement. Keeping a strong cord guard on your tool will help will cord life. This cord guard is compatible with the tools listed below, but it is not guaranteed to fit any other power tools.

This authentic OEM sourced part which is specially made for use with Makita power tools. It is important to have a cord protector on your tool to improve friction, seal cable and protect it from a potential damage. The part provides an identical replacement for a missing or a faulty component that was installed on a new unit. Please make ...Read moresure to refer to the appropriate diagrams of your model for the correct location and application of this part. Keep in mind this high-quality strain relief is made of durable rubber and is sold individually.

This is a Genuine OEM replacement part designed for use with Makita Power Tools. It is Sold Individually. This metal Pan-Head Phillips Screw includes a washer. It is used in a variety of applications based on your tool.

Genuine Makita replacement part. This pan-head phillips screw includes a washer. It is sold individually.

This pan head screw is a genuine replacement hardware sourced directly from original equipment manufacturer. It is specially produced for use with a variety of power tools. Please make sure to check appropriate diagrams for your tool to ensure the correct location and applications of this hardware. Includes one (1) metal screw and a washer.