36315459992 Kenmore Dishwasher - Overview
Sections of the 36315459992
[Viewing 3 of 3]
Keep searches simple, eg. "belt" or "pump".
Lower Front Dishrack Wheel
PartSelect #: PS259136
Manufacturer #: WD12X271
This wheel is located on the front lower rack. It includes the axle. Sold individually.
$28.95
Special Order
Corner Tub Baffle - Lower Left
PartSelect #: PS263964
Manufacturer #: WD8X228
The left and right side baffles should be installed/replaced at the same time. Right side baffle is sold separately.
$22.95
Special Order
Door Gasket - White
PartSelect #: PS958908
Manufacturer #: WD08X10057
This one piece dishwasher door gasket provides a water tight seal to keep water from leaking out of your dishwasher.
$104.33
Special Order
Silverware Basket (Grey)
PartSelect #: PS261346
Manufacturer #: WD28X265
This silverware basket is gray.
$115.40
Special Order
Upper Roller and Axle - Kit of 4
PartSelect #: PS3486910
Manufacturer #: WD12X10327
This is a kit of 4 upper rollers and axles.
$38.00
Special Order
Hinge Arm Link
PartSelect #: PS259336
Manufacturer #: WD14X10009
The hinge link on your dishwasher connects the spring to the dishwasher door hinge. If the hinge link becomes cracked or damaged, you may not be able to shut or lock your dishwasher door properly. In ...
$17.70
Special Order
Rinse Aid Fill Cap
PartSelect #: PS2351824
Manufacturer #: WD12X10284
This part helps keep the rinse aid the dispenser until its needed.
$78.79
Special Order
Water Inlet Valve
PartSelect #: PS259368
Manufacturer #: WD15X10003
This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of wat...
$111.45
Special Order
Pump To Wash Arm Rubber Connector
PartSelect #: PS259558
Manufacturer #: WD18X214
This connector has female threads.
$72.67
Special Order
Drain Solenoid and Bracket Assembly
PartSelect #: PS1481923
Manufacturer #: WD21X10268
This valve opens in order for the water to drain out of the dishwasher.
$79.98
Special Order
Sump Housing
PartSelect #: PS259557
Manufacturer #: WD18X213
This part is the replacement sump housing or sump insert for your dishwasher. It is made of plastic and is approximately 7 inches by 5 inches. The sump housing is attached to the bottom of the dishwas...
$84.13
Special Order
Common Symptoms of the 36315459992
[Viewing 10 of 10]Leaking
Fixed by
these parts
these parts
Show All
Not draining
Fixed by
these parts
these parts
Show All
Not cleaning dishes properly
Fixed by
these parts
these parts
Show All
Will not dispense detergent
Fixed by
these parts
these parts
Show All
Will not fill with water
Fixed by
these parts
these parts
Show All
Door latch failure
Fixed by
these parts
these parts
Show All
Door won’t close
Fixed by
these parts
these parts
Show All
Will Not Start
Fixed by
these parts
these parts
Show All
Noisy
Fixed by
these parts
these parts
Show All
Not drying dishes properly
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
The rollers on the upper rack broke
There are eight guides that hold the rack rails in place. Use a Phillips screwdriver to remove the top two guides on each side in order to remove the rack from the dishwasher. The plastic axles on the rack and the rollers snap on. Use the hammer and punch to bend the metal clip on one end of the rail. Remove the plastic end piece then slide the rollers out. Place two new rollers in the rail and put the plastic end piece on. Use the hammer and punch to bend the metal clip back into place. Snap the rails on the rack and set the rack on the guides in the dishwasher. Replace the top guide using the screwdriver, you will have to twist the rails in order get them in between the
guides.
guides.
Parts Used:
-
Carl from Fairfield, TX
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
545 of 576 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Wheel broken off bottom rack
Open the tiny plastic package in inserted the wheel onto the "axle". Opened the dishwasher, pulled out the bottom rack and snapped the wheel onto the rack. Done!
Parts Used:
-
Julie from Maumee, OH
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
503 of 520 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Broken upper rack roller, rack kept falling off the track
Used the pliers to remove the broken roller. It came off in pieces. Slid new one on.
Cap on end of roller track was a bit of a challenge. It sort of twists & pulls off.
Cap on end of roller track was a bit of a challenge. It sort of twists & pulls off.
Parts Used:
-
Doug from Columbus, OH
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Pliers
396 of 404 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!