Models > 36314074790

36314074790 Kenmore Dishwasher - Overview

Sections of the 36314074790

[Viewing 3 of 3]

Manuals & Care Guides for 36314074790

Click to download
Keep searches simple, eg. "belt" or "pump".
Lower Rack Wheel Kit - 8 Pack – Part Number: WD35X21038
Lower Rack Wheel Kit - 8 Pack
★★★★★
★★★★★
(56)
PartSelect #: PS11726733
Manufacturer #: WD35X21038
If your dishwasher door will not close, is noisy when operating, or the dishes are not cleaning properly, you might need to replace one or more of the wheels. Each wheel and axle are made of plastic a...
$48.90
  Special Order
Lower Front Dishrack Wheel – Part Number: WD12X271
Lower Front Dishrack Wheel
★★★★★
★★★★★
(5)
PartSelect #: PS259136
Manufacturer #: WD12X271
This wheel is located on the front lower rack. It includes the axle. Sold individually.
$12.92
  Special Order
Corner Tub Baffle - Lower Right – Part Number: WD8X227
Corner Tub Baffle - Lower Right
★★★★★
★★★★★
(3)
PartSelect #: PS263963
Manufacturer #: WD8X227
This baffle fits the lower right hand corner of some dishwashers. It is black and has a matching left hand lower corner baffle. It is recommended that you replace and install both left and right at the same time.
$16.00
  Special Order
Corner Tub Baffle - Lower Left – Part Number: WD8X228
Corner Tub Baffle - Lower Left
★★★★★
★★★★★
(23)
PartSelect #: PS263964
Manufacturer #: WD8X228
The left and right side baffles should be installed/replaced at the same time. Right side baffle is sold separately.
$16.00
  Special Order
RACK SLIDE END CAP – Part Number: WD12X10304
RACK SLIDE END CAP
★★★★★
★★★★★
(4)
PartSelect #: PS2370502
Manufacturer #: WD12X10304
The Rack Slide End Cap is a white one-inch plastic part which replaces the end cap for your dishwasher rack, preventing your rack from sliding too far. If you find the dish rack is causing the door to...
$14.06
  Special Order
Drain Valve Shaft Seal – Part Number: WD8X181
Drain Valve Shaft Seal
★★★★★
★★★★★
(4)
PartSelect #: PS263930
Manufacturer #: WD8X181
$38.86
  Special Order
Push On Nut – Part Number: WR2X7054
Push On Nut
★★★★★
★★★★★
(5)
PartSelect #: PS298353
Manufacturer #: WR2X7054
This push on nut is for your dishwasher or refrigerator. As the name suggests, it pushes into place, rather than being screwed in. It is approximately half an inch in diameter and is made of stainless steel.
$11.48
  Special Order
Silverware Basket (Grey) – Part Number: WD28X265
Silverware Basket (Grey)
★★★★★
★★★★★
(6)
PartSelect #: PS261346
Manufacturer #: WD28X265
This silverware basket is gray.
$68.14
  Special Order
Upper Roller and Axle - Kit of 4 – Part Number: WD12X10327
Upper Roller and Axle - Kit of 4
★★★★★
★★★★★
(5)
PartSelect #: PS3486910
Manufacturer #: WD12X10327
This is a kit of 4 upper rollers and axles.
$30.62
  Special Order
Pump To Wash Arm Rubber Connector – Part Number: WD18X214
Pump To Wash Arm Rubber Connector
★★★★★
★★★★★
(4)
PartSelect #: PS259558
Manufacturer #: WD18X214
This connector has female threads.
$30.67
  Special Order
Sump Housing – Part Number: WD18X213
Sump Housing
★★★★★
★★★★★
(2)
PartSelect #: PS259557
Manufacturer #: WD18X213
This part is the replacement sump housing or sump insert for your dishwasher. It is made of plastic and is approximately 7 inches by 5 inches. The sump housing is attached to the bottom of the dishwas...
$72.85
  Special Order
Impeller and Seal Kit – Part Number: WD19X10032
Impeller and Seal Kit
★★★★★
★★★★★
(1)
PartSelect #: PS259598
Manufacturer #: WD19X10032
This part helps stop your dishwasher from leaking. This kit includes the impeller, seal, blade, filter, skidder and skidder holder.   No Longer Available

Questions And Answers for 36314074790

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Common Symptoms of the 36314074790

[Viewing 10 of 10]
Leaking
Fixed by
these parts
Show All
Not cleaning dishes properly
Fixed by
these parts
Show All
Not draining
Fixed by
these parts
Show All
Will not dispense detergent
Fixed by
these parts
Show All
Will not fill with water
Fixed by
these parts
Show All
Door latch failure
Fixed by
these parts
Show All
Door won’t close
Fixed by
these parts
Show All
Noisy
Fixed by
these parts
Show All
Not drying dishes properly
Fixed by
these parts
Show All
Will Not Start
Fixed by
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
The rollers on the upper rack broke
There are eight guides that hold the rack rails in place. Use a Phillips screwdriver to remove the top two guides on each side in order to remove the rack from the dishwasher. The plastic axles on the rack and the rollers snap on. Use the hammer and punch to bend the metal clip on one end of the rail. Remove the plastic end piece then slide the rollers out. Place two new rollers in the rail and put the plastic end piece on. Use the hammer and punch to bend the metal clip back into place. Snap the rails on the rack and set the rack on the guides in the dishwasher. Replace the top guide using the screwdriver, you will have to twist the rails in order get them in between the
guides.
Parts Used:
Upper Roller and Axle - Kit of 4
  • Carl from Fairfield, TX
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers
529 of 542 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Lower rack wheel was melted
Unsnapped clip,and moved it 90 degrees. Slip wheel and clip off. Installed clip on new wheel. replaced new wheel. The wheel did not come with a new clip and was not suggested on the parts list. The existing clip was still OK but if it was not, I would have had to order a clip and wait. All in all, a good experience.
Parts Used:
Lower Rack Wheel Kit - 8 Pack
  • Mark from Huntingdon Valley, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
505 of 519 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Wheel broken off bottom rack
Open the tiny plastic package in inserted the wheel onto the "axle". Opened the dishwasher, pulled out the bottom rack and snapped the wheel onto the rack. Done!
Parts Used:
Lower Front Dishrack Wheel
  • Julie from Maumee, OH
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
490 of 494 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!