358351902 Craftsman Chainsaw - Overview
Sections of the 358351902
[Viewing 2 of 2]
Keep searches simple, eg. "belt" or "pump".
Bar
PartSelect #: PS9910275
Manufacturer #: 180SDET041
This is a genuine Craftsman replacement part sourced directly from the manufacturer. The bar is commonly found in Craftsman chainsaws. This part is made of metal, and is used to hold the cutting cha...
No Longer Available
Assy, Tool-less Knob
PartSelect #: PS9981933
Manufacturer #: 579107301
This replacement OEM part is specially designed for Poulan chainsaws. It is the tool-less knob assembly that attaches to the chain brake assembly. The knob provides a user with a comfortable grip to a...
No Longer Available
Common Symptoms of the 358351902
[Viewing 2 of 2]Will Not Start
Fixed by
these parts
these parts
Show All
Engine stops after a few seconds or minutes
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Would not start , had been sitting for years,
I did not write detail steps , basically remove old carb replaced with new one, reassembled started right up no adjustments were needed !
Parts Used:
-
Sherri from BREAUX BRIDGE, LA
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Screw drivers
11 of 13 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Worn out oil pump/burning chains
After checking several different videos, ordered the repair parts and two specialty tools( Clutch removal/install and a worm drive remover/installer) Total for parts and tools around 45.00. Much cheaper than the shop wanted, 85.00 to look at it plus parts. As for results I've used the chainsaw all afternoon no problem. Runs like it did 12 yrs ago. Pumps oil the would make Jed Clampet proud
Parts Used:
-
William from EVANSVILLE, IN
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers, Socket set
6 of 6 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
My neighbor brought the saw to me. It was locked up
He didn't want to spend alot of money on it. So I got the jug (Head) off and sanded it and the piston down while I waited on the new piston ring to get here. I found that it was easier putting the new ring in and the piston back into the jug (Head) was to go ahead and take the piston out so you could turn the jug (Head) upside down and it slid right in. It didn't take no time at all. And it now runs as good as new
Parts Used:
-
Marvin from KIRBYVILLE, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Screw drivers, Wrench (Adjustable)
4 of 4 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!