358350981 Craftsman Chainsaw - Overview
Sections of the 358350981
[Viewing 3 of 3]
Manuals & Care Guides for 358350981
Click to downloadKeep searches simple, eg. "belt" or "pump".
Bar Adjustment Kit
PartSelect #: PS9981582
Manufacturer #: 576752301
This OEM Poulan Chainsaw Bar Adjustment Kit is used to adjust the tension of the bar to keep the cutting chain tight for proper operation. It includes Retainer Ring, Pin and the Adjustment Bolt. Chain...
No Longer Available
Common Symptoms of the 358350981
[Viewing 3 of 3]Will Not Start
Fixed by
these parts
these parts
Show All
Engine stops after a few seconds or minutes
Fixed by
these parts
these parts
Show All
Cannot pull starter cord out or engine will not turn over
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Pull cord failed to retract
Removed cowling and spool. Spring drops in place without need for adjustment.
Parts Used:
-
Joel from West Roxbury, MA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
4 of 5 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Rope pulled out and didn't retrieve
Pulled rope pull assembly housing, 4 screws and removed center screw that holds the eps plastic gear and spring was under neath that and it was bent out of shape. Important part is install new spring with yellow painted end outward , toward housing! Lucky I bought two??
Parts Used:
-
Mike from Noble, OK
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver
4 of 6 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The saw started running too fast on idle and was over revving under light load.
I tried a few adjustment on the carb jets and the idle speed but it got worse. I opened it up and discovered that the carburetor was loose and the engine was sucking air at the carburetor mount. One of the nuts was lost so I ordered a replacement part and a spare in case it happens again. This saw has worn out at least 6 chains, three guide bars and a sprocket. Had one other repair a year ago when it broke a clutch spring in the sprocket.
Parts Used:
-
Kenneth from Fremont, NE
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
3 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!