34-639 (Type 2) Delta Table Saw Accessories - Overview

This is a genuine manufacturer-sourced replacement part which is specially designed for use with Delta drill presses. It helps to distribute the pressure evenly while allowing parts to be secured safely. This is a standard hardware which has multiple applications based on your equipment. Please make sure to refer to the appropriate diagra...Read morems of your model for the correct location and application of this hardware. Keep in mind this high-quality item is made of durable metal and is sold individually.

This metal pin helps hold and align the blade guard or splitter pivot on a table saw. A loose, crooked, or hard-to-move guard may mean the pin is bent, broken, or missing. Before replacing it, inspect the pivot bracket, mounting holes, clips, and nearby hardware for wear. Confirm fit with the complete saw model, type number, and parts dia...Read moregram as there are multiple pins located in the units. Unplug the saw and lower the blade before service. Install the pin in the position shown, then make sure the guard moves freely and stays aligned before using the saw.

This cap screw is a genuine Delta replacement part that is supplied from original equipment manufacturer for use with power equipment. It is a standard hardware which has multiple uses depending on your model, please make sure to check appropriate diagrams for correct use and location of this hardware. Note this durable metal cap screw is sold individually.

This see thru guard is supplied from original manufacturer for use with Delta saws. This part helps to direct dust and trimmings away from the user. This will help to keep the work area clean as well as provide protection from the blade while unit is in operation. It is made out of clear plastic and it is sold individually. Please note th...Read moree hardware and bracket are both sold separately. To replace this guard you would need pliers.

The pivot bracket attaches to the see thru guard. This item is available as an individual replacement part. This is a genuine replacement part sourced from the original manufacturer for use with table saws made by Delta. A set of pliers may be necessary during the installation of this item. It is made of metal and will need to be replaced if it breaks.

This high-quality spring is designed for use with Delta saws. It is supplied by the original equipment manufacturer. The spring applies tension on the kickback finger allowing it to retract. Over time it may wear out and lose tension eventually requiring a replacement. It is made of high-quality metal and is sold as an individual componen...Read moret. Make sure to check the diagrams of your model for the exact location and the correct installation of this spring. You will need a screwdriver to remove the push pin that holds the old spring.