34-338 (Type 1) Delta Table Saw - Overview

This set screw is a genuine OEM sourced replacement part. It is commonly used on a variety of Delta and Porter Cable power tools. A set screw is used to secure an object within or against another object. Please make sure to check appropriate diagrams for correct location and use of this set screw. You will need a hex key/allen wrench to install or remove this item.

This is an authentic manufacturer-supplied part which is specially made for Delta equipment. It is one of the special screws utilized to secure the nameplate. Please refer to appropriate diagrams of your model for the exact location and use of this hardware. This high-quality drive screw is made of durable metal and is sold individually. ...Read moreNote, the screw is installed into a pre-drilled hole. You will need a hammer to secure this component.

This is an original Delta replacement part manufactured for use with drill presses and table saws. The special hex nut has multiple applications depending on the model drill press or table saw. This hex nut is sold as an individual replacement part, please see model diagram for part location and usage.

This special nut is priced individually and fits next to the lock washer. It is made out of metal and will need to be replaced if it becomes stripped or broken. A wrench will be needed during the installation of this part. The nut is an authentic part from Delta to be used in drill presses.

Genuine Delta replacement part, this item is sold individually. The purpose of the is nut is to secure the blade of the Table Saw to the Saw Arbor. It is a left hand ACME thread. It is used on all of the right tilting Table Saws listed below.