332 (Type 2) Porter Cable Sander Polisher - Overview

This sander pad is a genuine Porter-Cable replacement part. It will directly replace a worn or damaged sander pad. This pad has a smooth sanding surface for use with adhesive (sticky) sandpaper. The pad attaches with three central mounting screws, and has five vacuum holes. It is five inches in diameter. This pad is not compatible with ho...Read moreok and loop (Velcro) sandpaper. This sander pad is compatible with the Porter-Cable sanders listed below.

This is a genuine DeWalt replacement power cord, specifically designed for use with double-insulated tools. Built for durability and safety, it features two wires and two prongs, eliminating the need for a ground wire. The cord measures 8 feet in length and uses 18-gauge wiring, offering a reliable connection and flexible reach for your p...Read moreower tool needs. It’s sold individually and is compatible with the models listed below. Installation requires careful attention: the new cord wires must be properly inserted into the wire terminals, and the cord should be routed correctly to avoid pinching when reassembling the tool’s case or plate. For best results, refer to your tool’s manual or consult a professional technician.

This Ball Bearing has metal shielding on both sides. This is a genuine Porter Cable replacement part that is sold individually. • Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This ...Read morereduces wear on the tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This is a Ball Bearing that is sealed on both sides. This is a genuine Porter Cable replacement part that is sold individually. • Ball bearings minimize friction between 2 parts in your tool that would otherwise spin and rub against each other. The balls or rollers take the load and spin, distributing the weight evenly while the mi...Read morenimal contact area of the balls reduce friction. This reduces wear on the tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This is a genuine manufacturer-approved replacement switch which is specially produced for use with Porter Cable and Black and Decker sanders. It is the part of the tool handling on/off operations of the tool, over time switches tend to wear out and may begin to fail eventually requiring replacement. This high-quality switch has a durable plastic body and it is sold individually.