3304-220 (Type 2) Black and Decker Router - Overview

This is a genuine OEM approved replacement part made for use with a variety of power tools. This wing knob has multiple applications based on the tool. Please refer to diagrams for correct use. It is made out of plastic with metal and it is sold individually.

This is a genuine OEM sourced replacement part which is specially produced for DeWALT and Black and Decker power tools. It allows a user to control the on/off function of the tool, over time components may wear out and begin to fail eventually requiring a replacement. Keep in mind this high-quality plastic body switch is sold individually.

A genuine item that is supplied directly from the original equipment manufacturer for use with DeWALT and Black and Decker power tools. It is a special hardware which has multiple applications depending on the model of your unit, make sure to refer to the appropriate diagrams for the correct location and use of this screw. Keep in mind th...Read moreis durable metal component is sold individually, you will need a Phillips head screwdriver to secure or remove it.

This spring-governor is an OEM part which is designed for DeWALT and Black and Decker equipment. It applies tension on the wing screw. Over time it may wear out and stretch eventually requiring a replacement. It is made of a high-quality metal and is sold as an individual component. Refer to the appropriate diagrams for your model for the...Read more exact location and the correct application of this hardware. Replacing it is a simple task that does not require any special tools.

It is an identical replacement for the pole piece that was installed on a new equipment. Check the diagrams for your specific model to ensure the exact location and the correct application of this hardware. This high-quality part is made of durable material and is sold as an individual item. It is supplied by the original equipment manufa...Read morecturer for DeWALT and Black and Decker routers. A screwdriver and pliers might be needed to take apart and reassemble the unit when performing this repair.

This is a genuine replacement part sourced from the original manufacturer for use with routers and planers. The special spanner wrench is commonly used to tighten and loosen the collet when changing router bits. This spanner wrench is available as an individual replacement part, please see model diagram for associative parts.

This cord protector is a genuine DeWalt replacement part and is sold individually. Cord Protectors are designed to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard.

This is an authentic OEM replacement part that is sourced to be used with plunge routers from DeWalt and Black & Decker. The metal depth stop is used to set the maximum cut depth to prevent the bit from cutting to deep. This item is available as an individual replacement part.

This is a genuine replacement part that is sourced from the original manufacturer to be used with routers from DeWalt and Black and Decker. The collet and nut are used as a vise that secures the router bits to the drive shaft. This item is available as an individual replacement part.

This Ball Bearing has metal shielding on both sides. This is a genuine Porter Cable replacement part that is sold individually. • Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This ...Read morereduces wear on the tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.