316711193 Craftsman Trimmer - Overview
Sections of the 316711193
[Viewing 2 of 2]
Keep searches simple, eg. "belt" or "pump".
SCREW:10-32X.562:#8P
PartSelect #: PS18442924
Manufacturer #: 1964
This is a genuine OEM sourced replacement housing screw designed for Ryobi and Troy-Bilt trimmers and blowers. It is commonly utilized to secure the starter housing. Please note, this metal housing sc...
No Longer Available
Common Symptoms of the 316711193
[Viewing 2 of 2]Will Not Start
Fixed by
these parts
these parts
Show All
Engine revs but trimmer head will not turn
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Fuel line broke
Removed the two screws holding the fuel tank to the main unit. Removed the two fuel lines and any stuck on rubber. Installed and installed two screws to mount the new tank. Slid fuel lines on their respective connectors. Done.
Parts Used:
-
Erik from ROBERTSDALE, AL
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
13 of 16 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Replace Starter Housing with broken pull cord.
1. Remove Shaft & clutch cover by removing 3 torx screws and loosening cinch bolt.
2. Remove clutch assembly with torx tool in center and then by cinching the shaft and turning spring assembly counter clockwise with an adjustable wrench.
3. Remove starter housing by removing 3 Torx bolts from the front and a screw from the back.
4 Reverse the process.
2. Remove clutch assembly with torx tool in center and then by cinching the shaft and turning spring assembly counter clockwise with an adjustable wrench.
3. Remove starter housing by removing 3 Torx bolts from the front and a screw from the back.
4 Reverse the process.
Parts Used:
-
Timothy from GAINESBORO, TN
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Wrench (Adjustable)
2 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Top drive shaft on my craftsman wc2200 grass trimmer broke
Drive shaft replacement was very easy . Minimal tools were required. Just disconnect the throttle cable, mainly for easier movement of trigger handle. Then remove the guide handle and the trigger mechanism and base. Reassemble reverse order.
Parts Used:
-
Thomas from TICKFAW, LA
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
3 of 7 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!