31517350 Craftsman Router - Overview

It is a genuine component that is supplied by the original manufacturer for use with Craftsman Routers. The Collet and retainer ring holds the router bit in place. The most common reason for replacing the collet and retaining ring is if the collet and the ring are lost or damaged, threads on the collet nut are stripped or the router bits ...Read morenot tightening on the collet. This part is sold individually. You will need Snap-ring pliers to install this part.

This is an original Craftsman replacement part manufactured for use with routers. This special wrench is used to loosen and tighten the collet when changing router bits. The wrench is available as an individual replacement part.

This is an authentic Craftsman replacement part, sourced from the original manufacturer for use with air compressors. The hex head screw is used to secure the motor assembly to the bracket on the tank of the compressor. These screws are sold in packs of eight pieces and the packs are sold individually.

This is an original part from Craftsman for use with Reciprocating Saws. The motor brush holder positions the motor brush against the armature in the motor. The most common reasons for replacing the motor brush holder is if the carbon brush is not contacting the armature, the carbon brush is loose (or misaligned) within the holder, the ho...Read morelder is melted around the carbon brush, the plastic brush holder is melted in the housing, the brush holder is loose or damaged, or there is loss of power to the saw. This part is sold individually. The tools that you will need to replace the motor brush holder is a Phillips screwdriver, flat-blade screwdriver, and long-nosed pliers.