315115790 Craftsman Reciprocating Saw - Overview

This authentic replacement part is designed for use with Ryobi power tools. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. Unfortunately, over time parts will wear out and may begin to...Read more fail eventually requiring a replacement. Keep in mind this high-quality component is made of durable metal and is sold individually.

A genuine item which is supplied directly from the original equipment manufacturer for use with Ryobi, Ridgid and Homelite power tools. The spring washer is designed to provide a tight seal between connected parts, over time it may wear out or simply get lost eventually requiring a replacement. Please make sure to refer to the appropriate...Read more diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality item is made of durable metal and is sold individually.

This set screw is a genuine OEM sourced replacement part used with Ryobi reciprocating saws. A set screw is a type of screw generally used to secure an object within or against another object. You will need a properly sized hex key which is also known as an allen wrench to tighten or loosen this screw. Please note this high quality metal item is sold individually.

This authentic replacement part is designed for use with Ryobi cordless reciprocating saws. Ball bearings are used to reduce friction between rotating parts. A needle roller bearing is a special type of a bearing which uses long, thin cylindrical rollers resembling needles. The rollers take the load and spin, distributing the weight evenl...Read morey while the minimal contact area of the roller reduces friction. Bearings experience constant wear from pressure, heat, vibration, and friction. Because of this, many bearings need to be periodically replaced. Make sure to check the diagrams of your model for the exact location and the correct installation of this component. It is made of high-quality metal and is sold individually. It is best to utilize a bearing press to remove the old part and secure the new one. You will need a screwdriver to take apart the housing in order to gain access to this needle roller bearing.

This is an authentic Ryobi replacement part manufactured for use with reciprocating saws. The slide bushing is used to guide the sliding rod and clamp assembly and is positioned between the rod on the connecting rod. This slide bushing is available as an individual replacement part, please see model diagram for associative parts.

The slide bushing goes next to the fiber sheet. This item is sold individually and is made of metal. It is an OEM replacement part for use in Ryobi saws. A set of pliers might be necessary during the installation of this part. It will require replacing if it becomes broken.

This replacement charger is a high quality item that is supplied directly from original equipment manufacturer for use Craftsman power equipment and tools. It is designed to connect to a standard U.S. outlet allowing user to charge batteries. Please note that a weak or defective battery can damage the charger. Weak batteries are batteries...Read more with bad cells. These type of batteries will not hold a charge. It will send a message to the charger to keep charging. This will eventually cause the charger to overheat and potentially smoke. Please note this durable plastic charger is sold individually.