3048-09 (Type 3) Black and Decker Circular Saw - Overview

This extension spring is sourced directly from the original equipment manufacturer for Black and Decker and DeWALT drill presses. It is an important component that applies tension on the knob for the edge guide. Over time it may wear out and lose tension eventually requiring a replacement. To ensure the correct installation of this hardwa...Read morere, check the diagrams of your specific model. This high-quality spring is made of a durable metal and is sold as an individual item. Replacing it does not require any tools, remove the knob and replace the spring.

This part is an OEM genuine replacement plug for Craftsman tools. The housing of this plug is made of a high quality durable material. It comes complete with neutral, hot and ground prongs, in order to make a safe and complete circuit. The connecting screws do come with this part, however the tools needed for replacing this part may vary....Read more Please see our repair forum for instructional videos to aid in the replacement of this part.

Included in part number 448671-03

This is an authentic replacement part sourced directly from the manufacturer. The O-ring is commonly found in power tools such as table saws, reciprocating saws, and impact wrenches from DeWALT and Black & Decker. This part is made of flexible rubber, and may be found in various locations in the machine, depending on model. Please be a...Read moreware that there are different O-rings used in the machine. Refer to the parts diagram to be sure of ordering the correct part. This item is available as an individual replacement part.

This durable item is supplied by the original equipment manufacturer. It is specially designed for use with DeWALT and Black and Decker saws. As the armature rotates inside the motor housing, electrical current is transferred through carbon brushes, which are held in place by small springs. When functioning correctly, these springs apply ...Read morejust enough pressure on the brushes to ensure smooth and consistent contact with the armature. Too much pressure will cause the brushes to chatter, chip and vibrate against the spinning armature. Too little pressure (or excessively worn brushes) can result in visible arcing, decreased performance, power fluctuations or a total loss of power to the motor. Make sure to refer to the owners manual and the diagrams of your model for the correct installation. This high-quality item includes one durable carbon brush with an attached lead wire and a plate. Replacing this part is a simple task, simply remove the brush cap, take out the old brush and secure the new one with the cap. You will need a screwdriver to perform this repair.

This manufacturer-sourced item is specially designed for use with DeWALT and Black and Decker saws. It is an identical replacement for a missing or damaged plug that was originally installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this component. Keep i...Read moren mind this high-quality item is made of durable material and is sold individually.

Included in part number 388431-00

Included in part number 144074-71