2820 (Type 1) Black and Decker Cordless Drill - Overview

This is a genuine OEM supplied replacement part designed for use with drills/drivers. This screw helps to secure the chuck to the unit. This is a reverse thread, oval-head Torx screw, made out of metal and it is sold individually. Requires a Torx screwdriver to install or remove this screw.

This is an authentic DeWALT replacement part. The spring is commonly found in DeWALT power tools such as drills and screwdrivers. This is a metal part used to hold the shifter switch in place. This part is sold individually.

This brush kit is supplied directly from original equipment manufacturer. It is a genuine replacement item that is specially designed for use with drills/drivers. Carbon brushes are some of the most commonly replaced items. Due to normal use and friction brushes will gradually wear down requiring replacement. It is advised to replace both...Read more brushes at the same type. This set includes two (2) carbon brushes, two (2) metal brush holders with springs and two (2) lead wires. You would need a screwdriver to complete this job. • Make sure the unit is unplugged • Remove the housing screws • Separate the housing halves • Disconnect lead wires • Take out old brushes and replace them with the new ones • Reassemble and test the tool

This is an authentic OEM sourced replacement keyless chuck which is specially designed for use with Dewalt and Black and Decker drills. It allows a user to secure a drill bit. The ratcheting action clicks the jaws tightly into place for reduced bit slippage. If your drill's bit retention is suffering, the rotation feels stiff, or the chuc...Read morek has seized up entirely, a new chuck should fix the problem. This high-quality component is sold individually, please note the hardware to secure it is sold separately.

This item is a genuine DeWalt replacement part that is intended to be used with cordless drills and drivers. The bit clip can be used as a direct replacement of the original clip that would have been installed on a new drill. The clip snaps onto the side of drill's housing and is used to store frequently used drill bits. This item is priced as a single replacement part.

This is a genuine OEM sourced replacement part, it is specially designed for use with Dewalt and Black and Decker electric drills and screwdrivers. It is the main lever which allows a user to change the direction in which the chuck is rotating. Please note this high-quality plastic lever is sold individually.

This is a genuine replacement part sourced directly from the manufacturer. The foam seal is commonly found in drills and screwdrivers from DeWALT and Black & Decker. This part is generally placed between the motor and transmission housings. Over time it may become worn or damaged, and require replacement. You may require a screwdriver...Read more when replacing this part. This item is sold individually. Included in part number 391106-12

Included in part number 380264-09

This is an original DeWalt replacement part manufactured for use with cordless drills. This special screw can have different functions depending upon the model, but is often used to secure the two halves of a handle set. The screw is sold individually, please see model diagram for part location, and function.

Includes part numbers 152184-00 and 152479-00

This 9.6V battery is a genuine Dewalt replacement accessory, not generic or aftermarket. It is a high end XR (extended run-time) battery with a high amp hour rating allowing it to run longer between charges.rn rnThis battery is new from Dewalt and ships in retail display packaging. We also offer a wholesale version of this battery which ships in a plain brown box (see "Related Products" section below).