26742 (Type 4) DeWALT Angle Grinder - Overview

This screw is an OEM direct from DeWalt. The metal screw is made for use with many grinder devices, and is sold individually. This item is often utilized to secure the spindle assembly. A screwdriver is required for making the proper replacement. It is also encouraged to purchase a spare, as they can wear over time.

The bearing cup is an OEM sourced part that is used with Craftsman angle grinders. This is not an aftermarket imitation part. This item is used to secure the bearing on the commutator side of the armature within the motor housing assembly. This item is available as an individual replacement part.

Genuine Dewalt replacement part This brush is sold individually, 2 are needed for the tools shown below It is always best to replace both brushes, even if only one is worn. Worn brushes frequently are the cause behind a motor running poorly. Replacing brushes can fix a motor that's operating intermittently. New brushes can restore a ...Read moremotor's electric braking. Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

This is a genuine OEM replacement part, it is sold individually. This Ball Bearing is sealed on both sides. • Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. • This reduces wear on t...Read morehe tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This authentic item is supplied directly from the original equipment manufacturer for use with angle grinders made by DeWALT, and Black & Decker. The inner flange fits between the flange and the guard and is made of metal. If this part becomes broken it will need to be replaced and may require a wrench during the installation. This part is available as an individual replacement.

This is a genuine DeWalt replacement power cord, specifically designed for use with double-insulated tools. Built for durability and safety, it features two wires and two prongs, eliminating the need for a ground wire. The cord measures 8 feet in length and uses 18-gauge wiring, offering a reliable connection and flexible reach for your p...Read moreower tool needs. It’s sold individually and is compatible with the models listed below. Installation requires careful attention: the new cord wires must be properly inserted into the wire terminals, and the cord should be routed correctly to avoid pinching when reassembling the tool’s case or plate. For best results, refer to your tool’s manual or consult a professional technician.

This is an OEM part sourced directly from the manufacturer. This 17.64 oz container of grease is used to lubricate the system of DeWalt equipment in order to protect the inner working parts and extend the life of the tool. One container is included per order.