26742 (Type 1) DeWALT Angle Grinder - Overview

It is an authentic item that is supplied directly from the original manufacturer for use with DeWALT and Black and Decker equipment. This is the special spring cover for bearings utilized on the tools. It provides an identical replacement for a missing or a damaged hardware that was installed on a new unit. To ensure the correct applicati...Read moreon of this component please make sure to refer to the owners manual and the appropriate diagram of your model. Note, one high-quality bearing cover is included.

This is a genuine manufacturer sourced replacement part, it is specially designed for use with DeWALT and Black and Decker power tools. The purpose of the brush is to conduct the current in an electric motor which powers the tool, over time due to contact with an armature the material will wear away eventually requiring a replacement to e...Read morensure peak performance. It is a high-quality component which is made of durable carbon with an attached lead wire and is sold individually. Keep in mind the brush holder is sold separately.

Genuine Dewalt replacement part This brush is sold individually, 2 are needed for the tools shown below It is always best to replace both brushes, even if only one is worn. Worn brushes frequently are the cause behind a motor running poorly. Replacing brushes can fix a motor that's operating intermittently. New brushes can restore a ...Read moremotor's electric braking. Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

This is a genuine OEM replacement part, it is sold individually. This Ball Bearing is sealed on both sides. • Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. • This reduces wear on t...Read morehe tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This authentic item is supplied directly from the original equipment manufacturer for use with angle grinders made by DeWALT, and Black & Decker. The inner flange fits between the flange and the guard and is made of metal. If this part becomes broken it will need to be replaced and may require a wrench during the installation. This part is available as an individual replacement.

This is a genuine DeWalt replacement power cord, specifically designed for use with double-insulated tools. Built for durability and safety, it features two wires and two prongs, eliminating the need for a ground wire. The cord measures 8 feet in length and uses 18-gauge wiring, offering a reliable connection and flexible reach for your p...Read moreower tool needs. It’s sold individually and is compatible with the models listed below. Installation requires careful attention: the new cord wires must be properly inserted into the wire terminals, and the cord should be routed correctly to avoid pinching when reassembling the tool’s case or plate. For best results, refer to your tool’s manual or consult a professional technician.