25361114101 Kenmore Refrigerator - Overview

This bar end cap is sold individually.

This end cap can be used for the left side of either the freezer door or the fresh food door.

This left-side drawer rail helps support the meat or deli pan in your Frigidaire fridge. If your drawer is sagging, stuck, or hard to open, this part can fix it. It’s a sturdy replacement that fits many models and works with the matching right-side rail (sold separately). Just check your model number to be sure it fits.

This retainer bar is cut to fit your refrigerator and existing end caps.

This defrost timer will cycle for thirty minutes after every eight hours of run time.

This part is the replacement door shelf retainer bar end cap for your refrigerator. It is made of white plastic and measures approximately 3 inches by 4 inches. The door shelf retainer bar end cap is found at the end of the shelf retainer bar, which it connects to the refrigerator door. The main reason to change out the shelf retainer bar...Read more is if it is broken or missing, and you can’t connect the retainer bar to the refrigerator door. This part is for the right side of the end cap only. The left side end cap is sold separately. This is an authentic OEM part sourced directly from the manufacturer.

This 40-watt appliance light bulb is a reliable replacement for use in select ranges, refrigerators, freezers, and microwaves. It provides bright, consistent lighting to help you see clearly inside your appliance. Installation is simple—just unscrew the old bulb and replace it with the new one. If the existing bulb is broken, disconnect p...Read moreower and use needle-nose pliers to safely remove the remaining base. Sold individually, this bulb is a commonly replaced part—consider keeping a spare on hand.

This part is the middle retainer bar end cap for the left side of your refrigerator door. It is designed to hold the retainer bar in place, and prevent food and beverage items from slipping out when the door is opened. It is made of white plastic, and is sold individually. This is a genuine OEM part, which comes directly from the manufacturer.

This defrost thermostat is a critical component in the refrigerator’s defrost system, designed to prevent overheating during the defrost cycle by regulating the temperature around the evaporator coils. Positioned within the freezer compartment, it monitors coil temperature and interrupts power to the defrost heater when safe limits are re...Read moreached. A malfunctioning thermostat may result in uneven cooling, excessive frost buildup, or a warm refrigerator compartment despite a cold freezer. Replacing this part restores proper defrost function and helps maintain consistent internal temperatures and energy efficiency.

This kit includes the motor, clips and terminal connectors. This part has been updated by the manufacture. This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.

Frost near the door, long cooling cycles, or a warm refrigerator can result from a cracked or twisted fresh-food door seal. The gasket forms a tight barrier between the door and cabinet, helping hold cold air inside. First check for spilled food, loose hinges, bent door parts, or shelves that stop the door from closing. Match the replacem...Read moreent to the full appliance model before ordering. Disconnect power and move food to a cooler during the repair. Smooth shipping creases with warm water or low heat, but do not overheat the material. Install the seal without stretching it, then test several spots around the closed door with a sheet of paper.

This part is attached to the compressor. It helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.