198800 Kenmore Ice Maker - Overview

Diagrams for 198800

See every part. Know exactly what you need.

Parts for the 198800

$10.50

Screw

Part #WP488729

Metallic screw that is less than an inch long. Does not include the plastic washer.

$15.06

Speed Nut

Part #WP486692

This part measures 1/4-20 inch. Sold individually.

$10.46

Screw

Part #WP487353

$10.53

Washer Screw

Part #WP912618

Sold individually.

Ice Grid Cutter

Part #2174861

Used on freestanding ice makers.

Plug

Part #758597

$54.95

Filter Drier Tube

★★★★★

(1)

Part #W10843121

This filter dryer is for refrigerators and filters refrigerant that travels through the sealed system of the refrigerator.

Condenser Fan Motor Kit

Part #978483

This motor operates the fan to help circulate the air for cooling of the compressor and the coils. It also helps to evaporate the excess water located in the drain pan.

$11.65

Screw

Part #WP965173

Sold individually.

$9.85

Rivet

Part #WP596788

Sold individually.

WIRE, CONNECTOR

Part #227991

GRID-CLIP

Part #759197

Repair Tips From Fixers Like You

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

Ice machine grid cutter had failed. All necessary was to pull old one and replace with new one. Hardest part was to remove the cover face plate on the front of grid cutter. The rest was a piece of cake. Now my ice machine works perfect and produces a ton of ice quickly and nicely.

4 of 5 people found this instruction helpful.

Charles from Bryant, AR
Really Easy
15 - 30 mins
Pliers

I removed the two wing nut type screws and pulled grid cutter out and then disconnected both the electrical power plug and the light power plug. Then I removed the front face plate and put it on the new grid cutter after cleaning and re-inserted the new grid cutter into ice machine along with re-connecting the electrical and tighten wing ... Read more

Read less

Was this helpful?

Icemaker would not make ice. Diagnosed problem as being the cutter which was not cutting the ice thereby causing the machine to cycle draining the water receptacle.

3 of 4 people found this instruction helpful.

Thomas from Warner Robins, GA
Really Easy
15 - 30 mins
Screw drivers

Removed two thumb screws holding old cutter in place, Replaced old cutter with replacement part the same way I removed the old cutter. Problem solved.

Was this helpful?

Ice wouldn't melt into the small squares

2 of 2 people found this instruction helpful.

Cecil from Indian Wells, CA
Really Easy
Less than 15 mins
Pliers

At the top of the unit is the grid-cutter, to remove, I unscrewed the two turn screws (usually can do by hand but mine were a little tight so I used pliers to turn them). I slid the unit out and disconnected the power supply and light switch. I removed the plastic cover on the front and put it on the new grid cutter, lining up the light ... Read more

Read less

Was this helpful?