1717 - Overview

Drive-Starter

This manufacturer approved replacement part is specially produced for use with Briggs and Stratton engines commonly installed on Toro lawn and garden equipment. It is utilized to keep the oil in the tank. Please note this durable plastic oil fill cap is sold individually.

This starter motor is for lawn and garden equipment engines. Starter motor spins the flywheel to start the engine. Wear work gloves to protect your hands when installing this part.

This is an authentic manufacturer-sourced replacement part which is specially designed for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. The purpose of this gasket is to provide a tight seal for the float bowl, please make sure to refer to the appropriate diagrams of your model for the correct locat...Read moreion and application of this hardware. Keep in mind this high-quality part is made of durable composite material and is sold individually.

This is an authentic manufacturer approved replacement air cleaner cartridge. It is specially made for use with Briggs and Stratton engines. Its purpose is to remove dust and other contaminants that could get in the engines with the air. This filter is made from pleated paper in a plastic housing and it is sold individually. Please note, ...Read morethe foam filter pre-cleaner is sold separately. Replacing this filter is a very simple task that does not require any tools. • Remove the air cleaner cover • Replace the air filter • Secure the cover

Hard starting may come from the recoil system instead of the carburetor or spark plug. If the rope pulls but the engine does not turn, the starter clutch may be worn, dirty, or jammed. The clutch turns the crankshaft during starting and lets go when the engine runs. First inspect the rope, rewind spring, pulley, flywheel screen, and clutc...Read moreh bearing. Confirm fit with the complete engine number. Remove the spark plug wire, wait for hot parts to cool, and keep dirt out of the bearing area. Test free movement before putting the shroud back on.