1439007100 Kenmore Range - Overview
Sections of the 1439007100
[Viewing 6 of 6]
Keep searches simple, eg. "belt" or "pump".
Agitator Assembly
PartSelect #: PS334559
Manufacturer #: 285574
Does not include softener dispenser. **** Some assembly required.****
$185.50
Special Order
2-Speed Drive Motor with Jumper Wire
PartSelect #: PS2003770
Manufacturer #: 12002353
This two speed split phase washing machine motor performs 1725 revolutions per minute in one speed and 1140 revolutions per minute in the other speed. This motor runs at 1/2 horsepower and it carries ...
No Longer Available
Common Symptoms of the 1439007100
[Viewing 1 of 1]
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Agitator wasn't spinning well
First I removed the screw that held it in place with a socket. The agitator became loose and easy to remove at this time so I lifted it from the washing machine. I then just placed the new agitator in place and replaced the screw being careful not to do it too tight. The replacing of this part was an easy job and thanks to Part Select it saves me hundreds of dollars.
Parts Used:
-
Nora from Marshall, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Socket set
26 of 31 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Motor Froze
Make sure to release the springs and pulleys before you try to tackle the bolts that hold the motor base to the bottom of the washer. Mine were a bit rusty and took some force to break loose. Also it's a good idea to take pictures of how everything sits before you disassemble as the pictures in the repair kit are not very clear. Other than that it was pretty straight forward. Wiring was a breeze. . . . Good luck
Parts Used:
-
Matt from Oxford, GA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:1- 2 hours
-
Tools:Nutdriver, Pliers, Screw drivers
22 of 28 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
the motor burnt out
took washer into the garage, removed front cover & disconnected the wiring. Then i removed the motor assembly. Piece of cake to finish job.
Parts Used:
-
walter from watertown, WI
-
Difficulty Level:Really Easy
-
Total Repair Time:1- 2 hours
-
Tools:Socket set
17 of 24 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!