137279580 Craftsman Band Saw - Overview

This is an authentic replacement part sourced directly from the manufacturer. The ball bearing is commonly found in Craftsman generators and power tools such as bench grinders and drill presses. This part is made of metal, and is generally used to allow components to spin freely. It may be found in various locations in the machine, dep...Read moreending on model. Please refer to the parts diagram to be sure of ordering the correct part. You may require a screwdriver or wrench when replacing this part. This is an individually sold item.

This is an authentic Craftsman replacement part, sourced from the original manufacturer for use with bandsaws. The pad connects to the base of the saw and is used to provide stable footing and balance. This is an authentic replacement part, please see illustrated diagram for associative parts.

It is a genuine item which is supplied directly from the original equipment manufacturer for use with Craftsman bandsaws. Over time the material may wear out and stretch eventually requiring a replacement. When putting the new tire on the wheel, it may seem too small however it is not, it will typically come approximately two or more inc...Read morehes smaller than the old tire you are replacing. You would need to put the new part in warm water to heat it enough to make it pliable enough to stretch with less resistance, note that it is advised to utilize two people in the stretching process. Keep in mind this high-quality rubber protector is sold individually.

This genuine manufacturer-sourced steel pin is made for Craftsman bandsaws. It is a standard hardware which may have multiple applications. Check the diagrams for your specific model to ensure the exact location and use of this part. It is an identical replacement for a missing or a damaged hardware that was installed on a new unit. One durable steel pin is included.

This is an authentic replacement part that has been sourced from the original manufacturer to be used with snowthrower engines. The switch is used to turn the starter motor on. This item needs to be actuated by a key that is sold separately. This item is priced as a single item.