133402-0555-A1 Briggs and Stratton Engine - Overview

This is the gasket that helps to provide an air tight seal for the breather assembly. It is a high quality item that is supplied by original equipment manufacturer for use with Briggs and Stratton and Toro equipment. It is made with durable composite material and it is sold individually. Over time gaskets tend to get compressed and deteriorate, eventually requiring replacement.

Genuine manufacturer approved carburetor needle valve for lawn and garden equipment engines. This item includes the seat. The needle valve opens and closes to control the flow of fuel into the carburetor. Make sure to disconnect the spark plug wire and drain all gasoline from the carburetor and fuel tank before starting a repair.

This manufacturer approved replacement part is specially produced for use with Briggs and Stratton engines commonly installed on Toro lawn and garden equipment. It is utilized to keep the oil in the tank. Please note this durable plastic oil fill cap is sold individually.

This replacement filter-pre cleaner is a genuine OEM sourced item, not an aftermarket imitation. It is a high quality item commonly utilized on Briggs and Stratton engines. This item adds a extra layer of filtration for the unit. This foam pre-cleaner is sold individually. Please note, the main pleated paper filter is sold separately. Yo...Read moreu will need a screwdriver to replace this item. • Remove the filter cover • Take out the old filter • Secure the new cleaner • Secure the cover

This is an original replacement part manufactured for use with outdoor power equipment. The oil seal is used with a variety of different models of equipment and is commonly used to form a seal where camshaft or driveshaft exit the crankcase. This oil seal is sold as an individual replacement part, please see model diagram for associative parts.

The grip insert attaches to the starter rope. This is an OEM Briggs & Stratton, Toro, and Lawn Boy part directly sourced from the manufacturer for use in blowers, engines, generators, lawn mowers, pressure washers, and vacuums. Keep in mind that this part is sold individually. It is made out of plastic and will need to be replaced if it breaks.

This is a Genuine OEM replacement part used on a variety of Lawn and Garden equipment. The key helps to secure Flywheel in place. This is a Metal Key and it is Sold Individually. You would need Pliers to replace this item.

This is a genuine Briggs & Stratton and Toro part sourced directly from the manufacturer for use in blowers, engines, generators, lawn tractors, and vacuums. The crankcase gasket is made out of a thin material. A wrench may be necessary during the installation of this item. It may become broken and will need to be replaced. This is available as an individual replacement part.