133232-1 Briggs and Stratton Engine - Overview

Models starting with 133232-1

Click on the best match to narrow your results.

Parts for models starting with 133232-1

$6.95

Gasket-breather

Part #27549S

This is the gasket that helps to provide an air tight seal for the breather assembly. It is a high quality item that is supplied by original equipment manufacturer for use with Briggs and Stratton and Toro equipment. It is made with durable composite material and it is sold individually. Over time gaskets tend to get compressed and deteriorate, eventually requiring replacement.

$7.95

Cap-oil Fill

Part #281658S

This manufacturer approved replacement part is specially produced for use with Briggs and Stratton engines commonly installed on Toro lawn and garden equipment. It is utilized to keep the oil in the tank. Please note this durable plastic oil fill cap is sold individually.

$17.95

Gasket-crkcse/005

Part #270125

$19.95

Link-mech Governor

Part #691814

$51.95

Shield-Cylinder

Part #694514

$7.95

Screw

Part #690323

$46.95

Shield-Heat

Part #690440

$8.95

Filter-pre Cleaner

Part #491435S

This is a genuine replacement pre-cleaner filter used with Briggs and Stratton engines. It is supplied directly from original equipment manufacturer. Its purpose is to filter out dust and debris from contaminating the engine. This filter is made out of paper and metal. This item is sold individually. Replacing this filter is a simple that that would only require a wrench.

$147.95

Kit-Oil Gard

Part #398182

This oil guard kit helps manage oil flow and containment within the system. Designed for durability, it supports proper lubrication and cleaner operation.

$27.95

Deflector-muffler

Part #395700

$9.95

Seal-o Ring

Part #691876

$147.95

Alternator

Part #494254

Common Symptoms of models starting with 133232-1

How this model fails, and the parts that fix it.

Will Not Start

Fixed by
these parts

Show All

Cannot pull starter cord out or engine will not turn over

Fixed by
these parts

Show All

Repair Tips From Fixers Like You

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

5 HP Briggs and Stratton chipper shredder - no spark

19 of 26 people found this instruction helpful.

Thomas from ALFRED, ME
Difficult
30 - 60 mins
Nutdriver, Pliers

Removed old sparkless magneto, replaced with new part PS9278124 Magneto, and still no spark. The only conclusion that I can draw, is this magneto is defective,

Was this helpful?

no gas to carb

14 of 23 people found this instruction helpful.

Dennis from MUKWONAGO, WI
Really Easy
15 - 30 mins
Nutdriver

pulled off fuel pump cover ,cleaned surfaces. Applied gasket sealer and replaced fuel pump diaphragm.

Was this helpful?

Old diaphragm dried up

6 of 9 people found this instruction helpful.

Steven C from CENTREVILLE, MI
A Bit Difficult
1- 2 hours
Nutdriver, Pliers, Screw drivers, Socket set, Wrench set

Tore carburetor off leaf blower and replaced. To do that require taking off the air cleaner removing the gas tank and all the brackets holding the controls on it. And keeping track of all the screws and Wires that control choke and throttle. I took several photographs. I did not need all the gaskets and jet’s that were included in the ki ... Read more

Read less

Was this helpful?