This is a Genuine OEM replacement part used on a variety of Lawn and Garden equipment. The key helps to secure Flywheel in place. This is a Metal Key and it is Sold Individually. You would need Plier...
This is an authentic Briggs & Stratton replacement part that has been sourced from the original manufacturer to be used with lawnmower engines. The durable plastic tank connects to the blower housing ...
This authentic item is supplied directly from the original equipment manufacturer for use with engines, outboard motors, portable generators, snowthrowers, and lawn mowers made by Briggs & Stratton an...
The camshaft is available as an individual replacement part. A wrench and a set of pliers might be necessary during the installation of this item. It is made out of durable materials and will need to ...
This is an authentic manufacturer-sourced replacement part which is specially made for use with Briggs and Stratton engines that are commonly installed on Toro lawn and garden equipment. It is a stand...
The stop switch is made of plastic and metal and helps to turn off the device. This is an authentic replacement part that is sourced from the original manufacturer for use with engines, generators, sn...
I have a solid understanding of small engines. This pressure washer was used twice in 2013, when purchased. Sat in a garage for a couple of years with gas in tank and carburetor. Owner was moving and after 7 years of moving it around he sold it at a garage sale. I took it home and took off gas tank and thoroughly cleaned it. Then went through the carburetor and let soak in cleaner. Cleaned up the spark plug, tested and has good spark. reinstalled carburetor but would not start. I knew I had gas issues. I ordered a carburetor kit and replace the needle valve and seals. Still would not start. Ordered a new carburetor and spark plug. Installed both. Two pulls and it runs like new. Advice: don't try to clean out old carburetor, just buy a new one and install.
