This thermal cut-off kit for a dryer includes one high limit thermostat with a limit of 250 degrees Fahrenheit, and one thermal cut-off fuse (309 degrees). This kit also includes flat heaters with jumper wires.
If you notice that your dryer is noisy or will not tumble, you may need to replace the tri ring. This part is triangular, and is less than an inch in size. Tri rings can be found both on the idler pul...
This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, an...
This high-limit thermostat with Terminal Extension Arm acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches 221 degrees Fahrenheit, this piece will shu...
The blower wheel is a squirrel cage type wheel whose purpose is to move the air through the room or appliance. The blower wheel spins on the motor shaft to blow air through the dryer drum and out through the exhaust.
This is a replacement bearing ring kit for your dryer. The bearing rings are found on the top and bottom lips of the dryer drum. If your dryer is unusually noisy, or the drum will not turn during oper...
Ask our experts a question about this model and we'll get back to you as soon as possible!
3 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
LINDSEY
November 29, 2019
My dryer do not get hot so do i just need to buy the thermal fuse
For model number 11061402311
Hello LINDSEY and thanks for writing.
There are several parts that could cause this. Most likely your
Your thermal cut of fuse # PS334299, next the cycling thermostat # PS11741405, next the high limit thermostat # PS11742185 We hope this helps. Please contact us anytime.
Hello Charles, thank you for reaching out. We looked into your model and found that this issue indicates that there may be a problem with the heating element or a blown thermal fuse. We found the exact-fit parts: Heating Element (Part number: PS334313), and Thermal Cut-Off Kit (Part number: PS334299). If this will not solve your problem then you may have to replace Dryer Cycling Thermostat (Part number: PS11741405). We hope it will solve your problem.
My dryer runs fine and the heat is working. But there is no air running through the vent. I took the back panel off and could see that the fan is not running. Is the motor bad ? Thanks..
For model number 11061402311
Hi Steve, thank you for reaching out. Based on our research, we would recommend checking the blower wheel if it is stuck or damaged. If that is not the case, then you probably have a defective drive motor, part number PS334304, and needs to be replaced to fix the issue. We hope this solves your problem!
First tried heating element and thermal fuse with no luck. Ordered thermal cutoff and fixed problem. Had I used an ohm meter first I would have determined problem before having ordered heating element and fuse, as both had resistance. I wast just lazy and ordered the took the most common failed components first before taking dryer back off.
I ordered all the thermal sensors for the dryer. They arrived two days later and they were the correct parts. It took me about 1/2 hour to replace all three sensors and now the dryer works like new again. My wife was very pleased, so was I.
I basically took the back offo the drive, then detach the heating coil. Afterwards had to go back in and change the thermal regulator an the job was completed.