11051730 Kenmore Washer - Overview

Diagrams for 11051730

See every part. Know exactly what you need.

Parts for the 11051730

Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Thrust – Part Number: WPW10121334
$9.85
In Stock
GEAR-AGITR – Part Number: 355469
No Longer Available
GEAR-AGITR
Part #355469
ALSO ORDER 1 285036 AGITATOR
No Longer Available – Part Number: NLA
No Longer Available
No Longer Available
Part #NLA
This part is discontinued from the manufacturer and is no longer available to purchase.
HEX AGITATOR DRIVE COLLAR – Part Number: 16209
No Longer Available
"O" RING (2 REQ
No Longer Available
"O" RING (2 REQ'D)
Part #10938

Common Symptoms of the 11051730

How this model fails, and the parts that fix it.

Noisy
Fixed by
these parts
Fixing
Show All
Will not agitate
Fixed by
these parts
Fixing
Show All
Burning smell
Fixed by
these parts
Fixing
Show All
Spins slowly
Fixed by
these parts
Fixing
Show All
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
belt was cracking and dryer was somewhat noisy
4 of 7 people found this instruction helpful.
  • Melody from Silverton, CO
  • Easy
  • More than 2 hours
  • Nutdriver, Screw drivers
I used your great video for pointers as to what to do. I took off the front, raised the top, vacuumed the whole thing up, that took quite a while. Took out the drum. Did more cleaning. Then took off the old retaining rings with retaining ring pliers, took off the old drum rollers and support. Replaced with new roller supports, washer, rol ler, washer and retaining rings. Then I replaced the belt. Tested it and turned the wrong way and it came off. Replaced and tested it again and I don't know why but it came off. Replaced the belt again, tested fine. Then I replaced the felt pads and glides, they were worn. I ended up asking my husband to help hold the drum so I could get the front back on. Replaced front and door. Tried the dryer. Works great AND very, very little noise. Note: when taking the wiring off the light and the door switch, I took photo's of those places with my cell phone and had them to look at to make sure the wiring was correct.
Read less
Was this helpful?
Thank you for voting!
Clanging of dryer when rolling
1 of 2 people found this instruction helpful.
  • John from Bel Air, MD
  • Easy
  • 15 - 30 mins
  • Nutdriver, Screw drivers
Followed video on PartsSelect website, they made it real easy.
Was this helpful?
Thank you for voting!
View More