This is a replacement clutch assembly or cam kit for your washer. The clutch assembly is mounted on the drive shaft on the bottom of your washer. You may need to replace the clutch assembly if the spl...
This water inlet valve is for washers.
The water inlet valve controls the water flow into the washer.
Unplug the washer and shut off the water supply before installing this part. Wear work glove...
This clamp helps to prevent leaking by holding the end of water hose in place.
$13.81
In Stock
Questions And Answers for 1105142511
Ask our experts a question about this model and we'll get back to you as soon as possible!
3 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Donald
January 27, 2022
What's wrong with your washer when it's spin it shakes
For model number 1105142511
Hi Donald,
Thank you for your question. If your washer shakes and moves during the spin cycle, there are some parts that you will need to check to see which one is causing the issue. You will need to check the suspension rods, the leveling legs and the tub ring. We have included a link that you may reference on how to check these parts. Once you have determined the part you need, please feel free to call customer service. We are open 7 days a week and anyone will be happy to assist you. We look forward to hearing from you!
Hello Roger, Thank you for your inquiry. Researching the model number that you have provided, we show the suspension rod kit with springs as part# PS11703290. We hope this helps.
the washer isn't filling up all the way, what could cause that?
For model number 1105142511
Hello Betty, thank you for reaching out to PartSelect. According to our research, we would recommend you check if the water inlet hose is clogged or kinked. If that is not the problem, you may need to change the water inlet valve, part number PS12349267. The water inlet valve controls the water flow into the washer. We hope this information helps!
Well, first investigated and found loose nut on drive clutch. First take off the two screws with nut drive then cover off using a screwdriver blade to snap off the cover. Then socket ratchet to take off the nut on drive clutch. take off belt by slowly rotating the drive gear. two screws that hold the electronics to the upper drive clutch and put aside, so you can snap off the cover for drive clutch on upper part with screwdriver and off the parts come and install whole unit back as took it apart. Line up the new upper clutch so that is position as was before. (Using parts diagram helps a lot as www. partsselect.com has for you or Maytag.com.) Then put the electronic part board back on and the gear and nut. Make sure it is tight by several attempts to make sure it's snugged up good and then slowly roll belt back on the pulley and motor drive. Put your cover guard back on with two screws and done.