10RLCG702 General Electric Range - Overview

Diagrams for 10RLCG702

See every part. Know exactly what you need.

Parts for the 10RLCG702

Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Bake Element – Part Number: WB44X5043
$71.93
Special Order
Bake Element
Part #WB44X5043
DISCONTINUED – Part Number: WB21X5212
No Longer Available
DISCONTINUED
Part #WB21X5212
DISCONTINUED – Part Number: WB10X5001
No Longer Available
DISCONTINUED
Part #WB10X5001
DISCONTINUED – Part Number: WB9X5010
No Longer Available
DISCONTINUED
Part #WB9X5010

Common Symptoms of the 10RLCG702

How this model fails, and the parts that fix it.

Little to no heat when baking
Fixed by
these parts
Fixing
Show All
Element will not heat
Fixed by
these parts
Fixing
Show All
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
The oven's bottom bake element burned up
19 of 23 people found this instruction helpful.
  • Dennis from Los Alamos, NM
  • Really Easy
  • Less than 15 mins
  • Socket set
First I turned the circuit breaker switch off for the stove unit. I then removed the two screws that hold the element in place at the back of the oven. I then pulled the element out about 3 inches and disconnected the two wires. I attached the new element, bolting the wires into place and then screwed the element back into place on the back wall of the oven. I flipped the breaker switch back on, and turned on the oven. I was done in roughly 15 minutes. The most difficult part was having to shine a flash light into the oven to replace the part, and negotiating the hard cold kitchen floor.
Read less
Was this helpful?
Thank you for voting!
The oven element burned completely into.
10 of 12 people found this instruction helpful.
  • John from Kiowa, CO
  • Really Easy
  • Less than 15 mins
  • Nutdriver
I first removed the two screws holding the element in place. Then I pulled the element out about 2 or 3 inches and then took out the 2 small screws holding the 2 wires in place. I then removed the old element and discarded it and installed the new one in the reverse order that I took out the old one. It was quite easy to do, only took abo ut 10 to 15 minutes total time.
Read less
Was this helpful?
Thank you for voting!
Burned out
6 of 11 people found this instruction helpful.
  • Jeff from Phoenix, AZ
  • Really Easy
  • Less than 15 mins
  • Screw drivers
First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires...)
Was this helpful?
Thank you for voting!
View More