This advanced refrigerator water filter utilizes Triple Filtration Technology to reduce a wide range of contaminants, including mercury, lead, and trace pharmaceuticals, ensuring cleaner and safer wat...
The lower door closing cam is used in refrigerator doors, it can be located on the fresh food side or the freezer side. It helps hold the door open. This cam is made out of plastic, so it might crack ...
The Door Cam is a black plastic part which helps the door pivot shut while keeping the door and hinge in proper alignment. Lubricating this part upon installation may help it move easier. It attaches...
This manufacturer-certified Pan Slide Track allows the drawer to slide in and out. It measures roughly 12 inches in length If this track is damaged or missing, you won't be able to move the drawer pro...
This water inlet valve supplies water to your refrigerator’s ice maker and dispenser. It includes a valve, tubing, and a coupling. The pre-filter bracket connector must be purchased separately if requ...
This icemaker can be used with 25-27 cubic feet refrigerators that have a vertical auger dispenser located on the freezer door. Reuse bottom bracket from the original icemaker and attach to the new.
This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch...
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Bill
May 25, 2023
Water is leaking from the top tubing in the back of the refrigerator that feeds into the ice maker. How do I reconnect that tube?
For model number 10655616400
Hi Bill, thank you for the question. Please follow the given instructions to reconnect the tube:
After pulling the appliance out and turning off the water supply, you will need to remove the back and bottom covers to expose the water valve where the water line connects. You will need to unscrew the valve from its mount to get to the bottom of the valve. With a 5/16 wrench, you can pull the waterline out of the bottom of the valve. You will now need to remove the brass clips that hold the water line to the back of the appliance. Next, open the freezer and remove the top shelves. You will then need to remove the ice maker access door and the ice maker itself. You will see the black tube at the top of the freezer, above the ice maker. You can move it from side to side until it comes loose. You will then need to slowly pull the tub out. You will continue until the water line is out. You will then reverse the steps to install the new water line, threading it back through the hole. We hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
The old tracks had been falling out consistently, causing the deli tray to fall on top of the food below it (which included the eggs, though none were broken since they were in a hard plastic container).
I had some difficulty getting the new track installed, however. All the parts lined up, but I just couldn't get the tracks to slide into place. After some brute force and about 10 minutes, they were finally installed.
Best thing about it is that it doesn't appear that these tracks are coming out easily! Mission accomplished!
removed flap door in front of icemaker...removed 3 screws with bolt heads...removed one additional screw with bolt head and ice unit slid out. I removed motor unit (pops out no screws). Replaced and had ice within 3 hours.
