10651122210 Kenmore Refrigerator - Overview

Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Refrigerator Crisper Drawer with Humidity Control – Part Number: WP2188656
$149.16
In Stock
Refrigerator Crisper Drawer with Humidity Control
★★★★★
★★★★★
(79)
Part #WP2188656
This is a genuine OEM approved replacement. The Crisper Drawer with Humidity Control allows you to adjust the humidity within the crisper. This can extend the life of your produce.
Refrigerator Lower Door Closing Cam – Part Number: WP2182179
$15.31
In Stock
Refrigerator Lower Door Closing Cam
★★★★★
★★★★★
(29)
Part #WP2182179
The lower door closing cam is used in refrigerator doors, it can be located on the fresh food side or the freezer side. It helps hold the door open. This cam is made out of plastic, so it might crack or wear down over time. If your door will not open and close properly you may need to replace the door closing cam. To successfully install this part, you will need a 5/16 nut driver and a small flat blade screwdriver. Before you begin, unplug your appliance and disconnect the water supply. Lubricating this part may help with installation. This replacement part is sold individually. This part will fit both the left and right side of your refrigerator door. To make the repair, remove the top hinge cover, then the top hinge support. Lift the door from the bottom support and remove the old door cams. Replace the cams, using a little lubricant if necessary, and place the door back on the lower hinge support. Replace the top hinge support and your repair is complete!
Refrigerator Crisper Drawer With Handle – Part Number: WP2188664
$108.53
In Stock
Refrigerator Crisper Drawer With Handle
★★★★★
★★★★★
(39)
Part #WP2188664
This OEM, clear convertible meat drawer can be used to store meats or vegetables and is designed for the lower portion of your refrigerator, generally. It has its own cold air duct to allow cold air from the freezer to flow into the drawer. You could have a broken or faulty drawer if you find that the food is kept within is spoiling or drying out quickly. The drawer should slide open and closed with ease. If your drawer will not easily slide open or closed, check the tracks that the drawer slides on. If the tracks are not damaged, the drawer itself could be at fault and should be replaced. Inspect it for visible damage like cracking or warping, which should be obvious. This part measures approximately 16 7/16 inches wide x 14 5/16 inches deep x 7 5/8 inches high and is a genuine OEM replacement part. It is sold individually. Note that there are several different types and options for the lower vegetable and meat drawers for your refrigerator, and you should check your user manual carefully to ensure that this is the drawer you are looking for.
Touch-Up Paint - White – Part Number: 72017
No Longer Available
Touch-Up Paint - White
★★★★★
★★★★★
(23)
Part #72017
This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, and freezers. This is a genuine OEM part and includes a brush applicator. Please remember to wear gloves to protect your hands when applying this paint.
Refrigerator Bimetal Defrost Thermostat – Part Number: WPW10225581
$48.43
In Stock
Refrigerator Bimetal Defrost Thermostat
★★★★★
★★★★★
(18)
Part #WPW10225581
If ice is building up in your freezer or if your freezer is getting too warm on the defrost cycle you may need to replace the bi-metal thermostat.
Refrigerator Slide-Out Shelf with Glass – Part Number: WPW10276348
$282.57
On Order
Refrigerator Slide-Out Shelf with Glass
★★★★★
★★★★★
(16)
Part #WPW10276348
This OEM glass shelf assembly is designed for use in a variety of refrigerator models, offering reliable support and visibility for stored food items. It features a sturdy white plastic frame measuring approximately 18 inches in length and 18 inches in width, with an integrated glass pane that provides a smooth, easy-to-clean surface. The shelf is intended to replace cracked, shattered, or weakened components that no longer support weight effectively. Installation is simple and tool-free: remove the existing shelf by sliding it out of the interior grooves, then align and insert the new shelf into the same position. This part is sold individually and does not include additional accessories.
Gallon Door Bin - Clear – Part Number: WPW10710203
$50.42
In Stock
Gallon Door Bin - Clear
★★★★★
★★★★★
(10)
Part #WPW10710203
Need a new shelf bin for your fridge door? This clear bin fits select Whirlpool, Kenmore, and Maytag models and snaps right into place—no tools needed. It’s made from strong, food-safe plastic and is perfect for storing bottles, jars, and even soda cans. If your old bin is cracked or broken, this replacement will help keep your fridge organized and looking fresh. Just check your model number to make sure it’s the right fit.
Snack Pan - Clear – Part Number: WP2309517
$141.31
In Stock
Snack Pan - Clear
★★★★★
★★★★★
(7)
Part #WP2309517
The snack pan in your refrigerator stores food and other items that you intend to keep cold. It is the top drawer in the refrigerator and is also the smallest of the three drawers in this model. It is made of clear plastic and slides into a drawer glide attached to the top glass shelf. The drawer measures 16 inches by 16-1/2 inches by 4-3/4 inches. If your snack pan is cracked or damaged, you may want to replace it. This drawer contains a series of ribs in the bottom of the drawer. Be sure to check the drawer glides and the glass shelf that correspond to the snack pan in your refrigerator if the pan will not slide in or out properly.
Refrigerator Screw – Part Number: WPW10661886
$17.45
In Stock
Refrigerator Screw
★★★★★
★★★★★
(2)
Part #WPW10661886
This mounting screw is a genuine OEM replacement part for the door handle in your refrigerator. If you are having trouble shutting the refrigerator door, or opening it, replacing this screw can help solve the issue. Replacing this part is easy and requires minimal disassembly of the refrigerator end cap handle. Your will need a screwdriver to complete this repair.
Evaporator Fan Blade – Part Number: WP2169142
$41.53
In Stock
Evaporator Fan Blade
★★★★★
★★★★★
(2)
Part #WP2169142
If your refrigerator or freezer is too warm, or making noises, you may need to replace the fan blade. The fan blade attaches to the evaporator motor, which is in the freezer section, to help circulate the cold air into the refrigerator and freezer sections. The fan blade is white in color and made from plastic. This is a genuine OEM part. Please be sure to disconnect the power to your refrigerator before starting your repair.
Screw – Part Number: WP489483
$17.55
In Stock
Screw
Part #WP489483
This screw is sold individually.

Questions And Answers for 10651122210

Ask our experts a question about this model and we'll get back to you as soon as possible!

Sort by:
  • 1
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Darrell - For model number 10651122210
January 29, 2022
Lights inside keep flashing.
Chris Boyle Profile
Hello Darrell, Thank you for your inquiry. We have researched the model you have provided and we would recommend checking the following parts to fix your issue: the light control board, the led light, the light switch, and the door switch. Also check the wiring for any loose connections or visible damage. Good luck with your repair.
$41.75
In Stock
Refrigerator Light Switch
$48.35
In Stock
LED Light
$48.35
In Stock
LED Light Control Board
$54.95
In Stock
Door Light Switch
1 person found this instruction helpful.
Was this helpful?
Thank you for voting!
Russ - For model number 10651122210
February 16, 2023
Power every were except fan motor and compressor..
Chris Boyle Profile
Hello Russ, thank you for your question. The Electronic Control Board PS11754327 is responsible for both so first check the wiring, and if it is all good then you may need to replace the board. We hope this helps.
$268.00
Special Order
Electronic Control Board
Was this helpful?
Thank you for voting!
Ben - For model number 10651122210
July 6, 2026
Why is refrigerator LED lights flickering?
Chris Boyle Profile
Hi Ben, thank you for your inquiry. Flickering LED lights inside a refrigerator are almost always caused by either a failing LED light module or a malfunctioning LED light control board. Unlike traditional bulbs that simply burn out, LED modules tend to flicker or strobe as their internal components degrade. If one module in the circuit is failing, it can cause all connected lights to flicker since they are often wired in series. If the modules look intact, the LED light control board is the next suspect. This board manages the voltage supplied to the lights. If it is failing or experiencing voltage drops it will cause the lights to blink rapidly or strobe rather than burn steadily. Glad to be of help!
$48.35
In Stock
LED Light
$48.35
In Stock
LED Light Control Board
Was this helpful?
Thank you for voting!
  • 1

Common Symptoms of the 10651122210

How this model fails, and the parts that fix it.

Watch our pros, then fix it yourself.

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
track of the pan become broken
426 of 450 people found this instruction helpful.
  • Darrell from Cedar Bluff, VA
  • Really Easy
  • Less than 15 mins
Buy a new crisper pan,slide out old one ,slide in new one
Was this helpful?
Thank you for voting!
Drawer guides broken
318 of 414 people found this instruction helpful.
  • Paula from Chesterfield, NJ
  • Really Easy
  • Less than 15 mins
Simply pulled out old drawer and replaced with new one. This broken drawer really bothered my wife so this simple repair earned me alot of points at home. Lord knows i can use all the extra points i can get. Thanks for the quick shipment of the part. 2 days from time of call to part on my door step. Thanks again
Was this helpful?
Thank you for voting!
Plastic bits dispensed from Ice Dispenser in Door
205 of 254 people found this instruction helpful.
  • john from seaford, VA
  • Easy
  • 15 - 30 mins
  • Nutdriver, Pliers, Screw drivers, Socket set
Removed Ice bin from Fridge

Removed all bolts on bin with nut driver...about six

Removed housing...be careful with spring on crusher/cube control rod

Removed C clamp on end of auger with small slotted screw driver and needle nose pliers.

Removed plastic nut on end of auger shaft

Remov ed Ice crusher jaws and laid them out in the correct order

Removed Ice propeller and installed new part

Put back together in opposite order

Easy
Was this helpful?
Thank you for voting!