These screws are original replacement parts from Craftsman, and are used with air compressors, drills, grinders, jointers, paint sprayers, lathes, sanders, snowthrowers, lawnmowers, miter saws, band s...
This is an authentic Craftsman replacement part, sourced from the original manufacturer for use with air compressors. The special gasket is used to seal the connection between the cylinder and the cra...
Removed the guard and belt. Heated the flywheel with a propane torch. Careful not to over heat it. Flywheel came off easily with a 3 point puller. Removed the cap and pulled the old seal out. Cleaned the bore in the cap to get all the oil out and dried it. Started the seal into the cap with the letters out. Carefully pushed the seal down into the bottom of the cap with a long socket slightly smaller than the bore. Put a little oil on the inside of the seal and put the cap back on. Reheated the flywheel somewhat again and tapped it back on the shaft with a brass drift. Put the belt and guard back on. Started the compressor. No more oil leaking around the shaft.
TURN OFF POWER TO UNIT REMOVE BOLTS ON TOP SIDE OF COMPRESSOR PUMP TO REMOVE PLATE. THERE ARE 2 SMALLER PLATES THAT COVER FLAPPER W/ 2 SMALL SCREWS ON EACH (MAKE NOTE OF SMALL TOP PLATE POSITION) REPLACE FLAPPER AND REASSEMBLE. THERE IS A GASKET ON LARGER PLATE THAT MAY NEED TO BE REPLACED.
