101933 Kenmore Range - Overview

Models starting with 101933

Click on the best match to narrow your results.

Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Screw – Part Number: WP486754
$10.65
Special Order
Screw
Part #WP486754
Sold individually.
Balancing Leg Spring – Part Number: 27239
No Longer Available
Balancing Leg Spring
Part #27239
Bell Plug – Part Number: 40008401
No Longer Available
Bell Plug
Part #40008401
This bell plug goes on the bottom of the agitator.
SPACER – Part Number: 00027928
$20.42
Special Order
SPACER
Part #00027928
Switch – Part Number: 00031921
$37.45
Special Order
Switch
Part #00031921
RING-RETAI – Part Number: 27197
No Longer Available
RING-RETAI
Part #27197
Spray - Almond – Part Number: 350956
No Longer Available
Spray - Almond
Part #350956
FILTER EXHAUST KET595 – Part Number: Y0042024
No Longer Available
FILTER EXHAUST KET595
Part #Y0042024
This filter assembly is just under eleven inches long and is not quite six inches wide. It is a metallic filter and it is used with some downdraft ranges.
Screw – Part Number: WP27001200
$10.48
In Stock
Screw
Part #WP27001200
Sold individually.
Spit Rod – Part Number: 31323
No Longer Available
Spit Rod
Part #31323
DISCONTINUED – Part Number: 485144
No Longer Available
DISCONTINUED
Part #485144
DISCONTINUED – Part Number: 29427
No Longer Available
DISCONTINUED
Part #29427

Exact Part matches for your search term

MEMBRANE, SINGLE – Part Number: 101933
No Longer Available
MEMBRANE, SINGLE
This part number matches the current model number 101933
Part #101933
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
shook violently in rinse mode... worse w light loads
8 of 13 people found this instruction helpful.
  • dennis from flushing, MI
  • Really Easy
  • 15 - 30 mins
  • Pliers, Screw drivers
Remove two sheet metal screws at bottom front. Tip up and remove front panel. Tip up top panel. Hold it up to allow access to rear of drum. Use soft piece of wire to loop around top of spring. Pull 4 springs up and off drum. Rotate the springs to release them from the base plate. Starting at the rear of the drum slip new spring end into washer base. Slip wire loop on the top of the new spring. Pull and stretch new spring onto drum. Repeat 3 more times. Replace front cover....you're done!
Was this helpful?
Thank you for voting!