100708-015 Briggs and Stratton Engine - Overview

This is a Genuine OEM replacement part used on a variety of Lawn and Garden equipment. The key helps to secure Flywheel in place. This is a Metal Key and it is Sold Individually. You would need Pliers to replace this item.

Genuine manufacturer approved carburetor needle valve for lawn and garden equipment engines. This item includes the seat. The needle valve opens and closes to control the flow of fuel into the carburetor. Make sure to disconnect the spark plug wire and drain all gasoline from the carburetor and fuel tank before starting a repair.

The grip insert attaches to the starter rope. This is an OEM Briggs & Stratton, Toro, and Lawn Boy part directly sourced from the manufacturer for use in blowers, engines, generators, lawn mowers, pressure washers, and vacuums. Keep in mind that this part is sold individually. It is made out of plastic and will need to be replaced if it breaks.

This is an authentic replacement part manufactured for use with small engines. Seals can deteriorate overtime, and it is recommended to replace worn seals when servicing an engine. This seal is the lower seal in the engine's sump, the seal is sold individually.

This authentic OEM replacement part fits a variety of Toro and Briggs & Stratton engines. An O ring is used to retain pressure between rigid parts. Its flexible material allows it to create a tight seal. Many different sizes of O ring are used in these engines; consult manual to be sure of correct placement. Sold individually.

This is a replacement carburetor overhaul kit for your small engine. The carburetor is essential to the overall performance of your engine, and the carb can get clogged up over time for a variety of reasons. When your carb becomes clogged, it is often a good idea to take it apart and replace the various parts inside by purchasing a carbur...Read moreetor kit. This is a 15-piece set and contains everything that you will need to do a total overhaul of your carburetor. You may want to purchase some carb cleaner as well, to ensure that the new pieces in the carb kit fit and adhere properly.

This spark plug terminal is supplied directly from the original equipment manufacturer. The metal terminal is designed to fasten the spark plug to the engine lead wire. This component is sold individually, and needle nose pliers are helpful with the repair. Please refer to the appropriate diagrams of your engine model for the proper application of this hardware.

This is an authentic OEM component from Briggs & Stratton. The magneto armature screw is compatible with many lawn and garden engines. The hardened metal screw helps to mount the magneto armature. A wrench is required for the removal and installation. The magneto armature screw is sold individually. It is recommended to refer to engine manual and diagrams for further instruction.

It is an authentic OEM supplied exhaust gasket that is designed to provide an air tight seal between the muffler and the exhaust pipe. This part is specially produced for use with Briggs and Stratton engines commonly installed on Toro lawn and garden equipment. Over time gaskets tend to shrink, become brittle and crack eventually requirin...Read moreg replacement. It is made of high-quality composite material and it is sold individually.