100 (Type 3) Porter Cable Router - Overview

This Porter-Cable router sub base is an OEM replacement part. It is found on 690 series routers and allows a router to glide smoothly on the routing surface. This sub base comes complete with the plastic sub base and three countersunk screws for installation.

This is an authentic manufacturer sourced replacement brush cap. It is specially designed for Porter Cable band saws and routers. The brush cap is used to secure the carbon brush in the holder. This item is made out of black plastic and it is sold individually. You will need a flat-head screwdriver to install or remove this brush cap.

This is an OEM part manufactured for Porter Cable. It is used in routers and other power tools. Bearings are used to reduce friction between moving parts. They provide steady and smooth operation while also stabilizing position. Bearings are high wear parts and may need regular replacement. Sold individually.

This is a Toggle type switch that has 2 leads attached and 2 washers on the base of the switch. This authentic Porter Cable replacement part is sold individually. rnrnSwitches are commonly replaced parts in power tools, handling all on/off and variable speed operations. They also have a role in electric breaking; they can momentarily rev...Read moreerse electrical polarity. Because switches use mechanical internals, they will degrade and wear out over time, eventually needing replacement. Some common signs of a broken or failing switch are:rn • The tool has stopped functioning - it refuses to start. rn • The tool operates intermittently, requiring multiple tries to turn on, until eventually it won't start at all.rn • The variable speed function and electric braking aren't working properly.

This is replacement ball bearing is a commonly used item on a variety of power tools. Bearings are specially designed to allow connected parts to rotate smoothly. The way it is build it will minimize friction between the rotating parts. This is a sealed metal bearing generally used with an armature. Includes one (1) bearing per order. St...Read moreeps to replace this bearing would be different from one model to another. However, general steps to complete this repair would be the same. You may need a screwdriver and pliers to finish this job. • Make sure the unit is unplugged • Remove the cover/housing • Disengage the brushes • Remove the armature • Remove the old bearing • Install the new bearing • Reassemble unit and test the equipment

It is an authentic item which is supplied directly from the original equipment manufacturer for use with electric power tools. This high-quality screw is a standard hardware which has multiple applications depending on the model of your unit, please make sure to refer to the appropriate diagrams for the correct location and application of...Read more this part. Keep in mind this part is made of durable metal and is sold individually.

This is a needle bearing that is open on both sides. This genuine Porter Cable replacement part is sold individually. • Ball bearings minimize friction between rotating parts in your tool. The balls or rollers bear the load and spin, distributing the weight evenly, while the minimal contact area of the balls reduces friction. This reduc...Read morees wear on the tool, allowing it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This cord is a genuine Porter Cable replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 3 Prongs • 3 Wires • 18 Gauge • 7 Feet Long • Porter Cable models: 6302 T4, 6902 T5, T6

Genuine OEM replacement part, this item is sold individually. The 874582 Clamp Knob is used to tighten the bases of all of the Routers shown below. It is used with part number 695526 Screw, to clamp the Router Motor in the base for the desired height of the motor.