093J00 (093J99) Briggs and Stratton Engine - Overview

Diagrams for 093J00

See every part. Know exactly what you need.

Parts for the 093J00

$24.95

Sealant-liquid

Part #100106

It is a genuine manufacturer-supplied item that is made for use with Briggs and Stratton engines that are commonly installed on a variety of lawn and garden equipment. This is a special liquid sealant which creates a tight fit between connected components. Refer to the owner's manual or a repair guide to ensure the correct application. Note, this high-quality sealant-liquid is sold as an individual item.

$15.95

Pin-piston/std

Part #298909

$26.95

Lever-governor Contro

Part #590520

$7.95

Screw

Part #691664

$6.95

Screw

Part #590552

$15.95

Spring-choke Return

Part #590740

$10.95

Seal-oil

Part #391483S

This is an authentic replacement part manufactured for use with small engines. This oil seal keeps oil inside the crankcase, and seals the shaft. It is recommended to replace the crankcase gasket when servicing the case, the gasket is available separately. The oil seal is sold individually.

$13.95

Seal-oil

Part #399781S

This is an authentic replacement part manufactured for use with small engines. Seals can deteriorate overtime, and it is recommended to replace worn seals when servicing an engine. This seal is the lower seal in the engine's sump, the seal is sold individually.

$5.95

Key-flywheel

Part #222698S

This is a Genuine OEM replacement part used on a variety of Lawn and Garden equipment. The key helps to secure Flywheel in place. This is a Metal Key and it is Sold Individually. You would need Pliers to replace this item.

$5.95

Seal-o Ring

Part #270344S

This authentic OEM replacement part fits a variety of Toro and Briggs & Stratton engines. An O ring is used to retain pressure between rigid parts. Its flexible material allows it to create a tight seal. Many different sizes of O ring are used in these engines; consult manual to be sure of correct placement. Sold individually.

$14.95

Rope-starter

Part #591108

$214.95

Crankshaft

Part #590538

This crankshaft converts reciprocating motion into rotational power within the engine. Manufactured for strength and balance, it supports smooth operation and reliable power transfer.

Repair Tips From Fixers Like You

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

Blown Head Gasket

7 of 8 people found this instruction helpful.

Isaiah from CHAMBERSBURG, PA
Really Easy
Less than 15 mins
Screw drivers, Socket set

This was an OHV motor so in order to get to the head, you must remove the valve cover and remove the push rods. Remove all four head bolts in an even star pattern. Remove the old gasket and scrape all remaining gasket gunk. Put new gasket on and tighten head back on with an even star pattern. Slide push rods back in and adjust valves to . ... Read more

Read less

Was this helpful?

Blown Head Gasket

3 of 3 people found this instruction helpful.

Michael from BOAZ, AL
Really Easy
30 - 60 mins
Nutdriver, Socket set

Remove the top cover and pull cord assembly. Remove the muffler cover. Lift off the gas tank and disconnect from the air filter box. Remove the air filter box and carb from the head cover as a single unit. Remove the head cover. You can leave the valve cover in place. Remove old gasket material. Clean surfaces. Replace gasket. Reassemble ... Read more

Read less

Was this helpful?

Push mower leaked under neath.

1 person found this instruction helpful.

Raymond from Coalport, PA
Easy
15 - 30 mins
Pliers, Socket set

Pulled the old seal out, replaced it with seal #391483S and so far looking good !

Was this helpful?