092988-1412-99 Briggs and Stratton Engine - Overview

Diagrams for 092988-1412-99

See every part. Know exactly what you need.

Parts for the 092988-1412-99

$12.95

Spacer-air Cleaner

Part #280374

$7.95

Cap-oil Fill

Part #281658S

This manufacturer approved replacement part is specially produced for use with Briggs and Stratton engines commonly installed on Toro lawn and garden equipment. It is utilized to keep the oil in the tank. Please note this durable plastic oil fill cap is sold individually.

$36.95

Spring-vert Rew Str

Part #390066

Spring-Vert Rew Str

$10.95

Seal-oil

Part #391483S

This is an authentic replacement part manufactured for use with small engines. This oil seal keeps oil inside the crankcase, and seals the shaft. It is recommended to replace the crankcase gasket when servicing the case, the gasket is available separately. The oil seal is sold individually.

$19.95

Muffler

Part #394569S

This is an authentic exhaust muffler specially designed for Briggs and Stratton engines commonly used on Toro lawn and garden equipment. It is supplied directly from original equipment manufacturer and it is sold individually. Muffler softens the noise coming from the engine and provides an additional layer of filtration of exhaust. This metal muffler is manufactured to meet EPA exhaust regulations.

$12.95

Gasket-choke Cover

Part #270571

$16.95

Tube-Breather

Part #230802

$10.95

Spring-choke Diaph

Part #261249

$5.95

Seal-o Ring

Part #270344S

This authentic OEM replacement part fits a variety of Toro and Briggs & Stratton engines. An O ring is used to retain pressure between rigid parts. Its flexible material allows it to create a tight seal. Many different sizes of O ring are used in these engines; consult manual to be sure of correct placement. Sold individually.

$13.95

Spring-condensor

Part #260374

$6.95

Gasket-air Cleaner

Part #271139S

$11.95

Clip-vertical Str

Part #299961

Common Symptoms of the 092988-1412-99

How this model fails, and the parts that fix it.

Will Not Start

Fixed by
these parts

Show All

Repair Tips From Fixers Like You

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

Could not keep an aftermarket muffler on the engine.

15 of 20 people found this instruction helpful.

Richard from KERNERSVILLE, NC
Really Easy
15 - 30 mins
Wrench set

Once I determined what OEM muffler I needed, installation was relatively easy. I have a 1982 4hp Briggs on my Snapper tiller. There was a 90* galvanized elbow coming out of the exhaust port, with a bezel nut to lock it down. Do not remove the elbow, even though it appears that you should. If you install the muffler without the elbow the m ... Read more

Read less

Was this helpful?

Muffler rusted out

7 of 18 people found this instruction helpful.

Snoopy from TYRONE, GA
Very Easy
30 - 60 mins

hand tightened with threads into threaded insert

Was this helpful?

Push mower leaked under neath.

1 person found this instruction helpful.

Raymond from Coalport, PA
Easy
15 - 30 mins
Pliers, Socket set

Pulled the old seal out, replaced it with seal #391483S and so far looking good !

Was this helpful?