This is an OEM approved replacement part designed for gas trimmers/brush cutters. Its purpose is to filter out dust and debris from the air that goes into the unit. Over time it will get dirty and clo...
This is a Genuine OEM replacement part used on a variety of Lawn and Garden equipment. The key helps to secure Flywheel in place. This is a Metal Key and it is Sold Individually. You would need Plier...
$5.95
In Stock
Order within the next 10 hrs and your part ships today!
This is a genuine replacement part that is OEM sourced to be used with lawnmower engines from Briggs & Stratton and Toro. The gasket is used to seal the connection between the body of the crankcase an...
This is an authentic OEM component from Briggs & Stratton. The magneto armature screw is compatible with many lawn and garden engines. The hardened metal screw helps to mount the magneto armature. A w...
This is an authentic manufacturer-sourced replacement part which is specially made for use with Briggs and Stratton engines that are commonly installed on Toro lawn and garden equipment. It is a stand...
It is a genuine OEM sourced replacement screw which is specially designed for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. Please refer to the appropriate diag...
This is a Genuine Manufacturer Sourced replacement part used on a variety of Engines. This part provides an air tight seal for mounting the Gas Tank. This part is made out of Composite Material and it...
$6.95
Special Order
Questions And Answers for 080202-1762-01
Be the first to ask our experts a question about this model!
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
Once I determined what OEM muffler I needed, installation was relatively easy. I have a 1982 4hp Briggs on my Snapper tiller. There was a 90* galvanized elbow coming out of the exhaust port, with a bezel nut to lock it down. Do not remove the elbow, even though it appears that you should. If you install the muffler without the elbow the muffler will parallel the the vacuum for the carburetor and can melt the rubber couplers. Use the elbow to direct the heat away from the carburetor. Use a pipe wrench to lock down the bezel nut because the weight of the muffler, especially under vibration, can work loose and fall down on the tine belt cover and melt it. The bezel nut that comes with the muffler should also be used to lock down the muffler to the threaded intake bracket that comes with the muffler, not to replace the bezel nut for the elbow.
