This is a genuine manufacturer-sourced part which is made for Briggs and Stratton generators. It acts as an adapter to connect the hose. Over time the part may wear out, become brittle and begin to cr...
This is a genuine replacement part sourced directly from the manufacturer. The valve fuel kit is commonly found in Craftsman pressure washers and generators. This part includes the valve made of hig...
This is an OEM part sourced directly from the manufacturer. The bearing carrier is commonly found in generators from Briggs & Stratton and Snapper. This part is made of metal, and is used to hold on...
This is a genuine item that is supplied directly from the original equipment manufacturer for use with Troy-Bilt and Briggs and Stratton pressure washers. It is an identical replacement for a missing ...
This item is sold individually and is made of plastic. The fuel quick connect goes between the fuel line kit and the fuel valve. A set of pliers may be helpful when replacing this part. It will requir...
This is an authentic item that is supplied directly from the original equipment manufacturer for Briggs and Stratton Generators. This kit includes one (1) female quick connect, one (1) Male quick conn...
$127.95
Special Order
Questions And Answers for 030253-0
Be the first to ask our experts a question about this model!
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
Put some dish soap on the rubber, push into the tank hole, slip 1x2 into the handle of the tank and over the new part and pry down pushing it into the hole. Took about 2 minutes.
old valve easily pulled out with screwdriver and pliers
install difficult due to 40 degree cold temp and bushing didn't want to squeeze into fuel tank hole
install required lots of liquid soap on bushing, which popped into place by using upward prying pressure from 3"X24" plywood braced into under-shelf of gas tank
used same technique to insert valve upward into bushing
