020588-00 Briggs and Stratton Pressure Washer - Overview

This authentic manufacturer-supplied part is specially designed for use with Briggs and Stratton, Troy-Bilt and Snapper pressure washers. It is a special hardware that helps to secure components. This is an identical replacement for a missing or a damaged retainer clip that was installed on a new unit. Note, it is made of durable plastic ...Read moreand is sold in a pack of four. Make sure to refer to the owner's manual and the appropriate diagrams for your model to ensure the proper replacement procedure.

This is an original replacement part manufactured for use with pressure washers. This quick change nozzle delivers a 40-¦ angle spray for use with several pressure washing applications. The white quick change nozzle is sold as an individual replacement part.

This is an authentic OEM replacement part for use with the pressure washers listed below. It is a quick connect nozzle with a zero (0) degree, straight line spray width. This cutting nozzle is the strongest stationary nozzle and is recommended for use on strong hard surfaces, as it can cause paint removal or scratches. Sold individually.

This water inlet kit delivers a controlled supply of water into the appliance, supporting proper operation during use. Designed for dependable flow and secure connections, it is commonly replaced when water supply issues or leaks occur.

This is a genuine OEM sourced component which is specially designed for Craftsman pressure washers. It is an identical replacement for a missing or damaged outlet that was originally installed on a new unit, please make sure to check the appropriate diagrams of your model for the correct location and application of this item. Keep in mind this high-quality part is made of durable metal and is sold individually.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Briggs and Stratton and Troy-Bilt pressure washers. The purpose of these components is to provide an air-tight seal between connected parts, please make sure to refer to the appropriate diagrams of your model for the correct location and a...Read morepplication of this hardware. Keep in mind this high-quality kit is sold individually, note that it includes six durable rubber seals.

This bottle of oil can be used in over 150 different types of machinery. It is most commonly used for pressure washers and generators from manufacturers such as Briggs and Stratton and Troy-Bilt. This detergent oil is warranty approved and specially compounded for warm weather use. Please note: it is important to avoid over filling your engine with oil.

This valve kit, also known as a check valve kit, is a genuine OEM replacement kit designed for pressure washers. It includes 6 valves each with a seal and spring. The valves are responsible for maintaining the appropriate pressure levels needed to operate the equipment efficiently. If the valves are worn down or damaged, you will notice l...Read moreow or no pressure, weak water flow, and water leakages. To access the valves, first remove the pump from the equipment engine. Pull out the faulty valves using a pair of needle nose pliers and set them aside. Apply a light layer of lubricant to the new valves and place them in their correct position. Reattach the pump to the engine to complete the repair.

This is a genuine OEM sourced replacement part that is intended to be used with pressure washers from Craftsman. The screen fits into the water inlet tube and is used to prevent debris from the hose from entering the pump assembly. This item is available as an individual replacement part.

This genuine OEM sourced replacement part is designed for use with pressure washers. If the pressure washer runs too long with out the release of water from the sprayer, the water will heat up inside the pump. Once the water gets to a certain temperature the thermal valve will open and release the pressurized hot water, to protect the pum...Read morep. If this happens too often you have a greater chance of damaging your pump. This valve consists of one (1) metal and one (1) plastic piece. To complete this repair you will need a wrench.