020572-02 Briggs and Stratton Pressure Washer - Overview

This water inlet kit delivers a controlled supply of water into the appliance, supporting proper operation during use. Designed for dependable flow and secure connections, it is commonly replaced when water supply issues or leaks occur.

This is a genuine OEM sourced component which is specially designed for Craftsman pressure washers. It is an identical replacement for a missing or damaged outlet that was originally installed on a new unit, please make sure to check the appropriate diagrams of your model for the correct location and application of this item. Keep in mind this high-quality part is made of durable metal and is sold individually.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Briggs and Stratton and Troy-Bilt pressure washers. The purpose of these components is to provide an air-tight seal between connected parts, please make sure to refer to the appropriate diagrams of your model for the correct location and a...Read morepplication of this hardware. Keep in mind this high-quality kit is sold individually, note that it includes six durable rubber seals.

This is a genuine OEM sourced replacement part that is intended to be used with pressure washers from Craftsman. The screen fits into the water inlet tube and is used to prevent debris from the hose from entering the pump assembly. This item is available as an individual replacement part.

This is a genuine item that is supplied directly from the original equipment manufacturer for use with Troy-Bilt and Briggs and Stratton pressure washers. It is an identical replacement for a missing or a faulty handle fastening kit that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for t...Read morehe correct location and application of these components. This high-quality kit is sold individually, keep in mind it includes two durable plastic grips and two bolts to secure them.

This genuine OEM sourced replacement part is designed for use with pressure washers. If the pressure washer runs too long with out the release of water from the sprayer, the water will heat up inside the pump. Once the water gets to a certain temperature the thermal valve will open and release the pressurized hot water, to protect the pum...Read morep. If this happens too often you have a greater chance of damaging your pump. This valve consists of one (1) metal and one (1) plastic piece. To complete this repair you will need a wrench.

The check valve is an authentic OEM part for pressure washers made by Briggs & Stratton and Troy-Bilt. During the installation process, a screwdriver might be needed to replace this item. This part is made out of plastic and metal and will need to be replaced if it breaks. It is sold as a set of six valves.

This is an authentic OEM part for use with Craftsman Pressure Washers. The quick connector also is known as the wand connects to the spray gun handle and houses the nozzle that directs the spray stream. The most common reason for replacing the wand is if it is leaking or damaged. This part is sold individually. The tool that you will need to replace the wand is Silicone grease (optional).