020569-02 Briggs and Stratton Pressure Washer - Overview

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Briggs and Stratton and Troy-Bilt pressure washers. The purpose of these components is to provide an air-tight seal between connected parts, please make sure to refer to the appropriate diagrams of your model for the correct location and a...Read morepplication of this hardware. Keep in mind this high-quality kit is sold individually, note that it includes six durable rubber seals.

This genuine OEM sourced replacement part is designed for use with pressure washers. If the pressure washer runs too long with out the release of water from the sprayer, the water will heat up inside the pump. Once the water gets to a certain temperature the thermal valve will open and release the pressurized hot water, to protect the pum...Read morep. If this happens too often you have a greater chance of damaging your pump. This valve consists of one (1) metal and one (1) plastic piece. To complete this repair you will need a wrench.

The check valve is an authentic OEM part for pressure washers made by Briggs & Stratton and Troy-Bilt. During the installation process, a screwdriver might be needed to replace this item. This part is made out of plastic and metal and will need to be replaced if it breaks. It is sold as a set of six valves.

This is an authentic OEM part for use with Craftsman Pressure Washers. The quick connector also is known as the wand connects to the spray gun handle and houses the nozzle that directs the spray stream. The most common reason for replacing the wand is if it is leaking or damaged. This part is sold individually. The tool that you will need to replace the wand is Silicone grease (optional).

It is an authentic high quality item that is supplied from original equipment manufacturer for use with Briggs and Stratton and Troy-Bilt pressure washers. This kit attaches to the base of the pressure washer to reduce vibration when the unit is turned on. This kit includes two durable rubber mounts, two metal washers, two bolts and two lock nuts.

The key is made of metal and attaches to the pump assembly. This item is available as an individual replacement part. This is a genuine Briggs & Stratton, Troy-Bilt, and Snapper replacement part for use in pressure washers, air compressors, and generators. An allen wrench and a wrench set might be required during the replacement of this part. It will need to be replaced if it becomes broken.

It is an OEM supplied Ez Start kit which is designed for Troy-Bilt and Briggs and Stratton pressure washers. This is a special mechanism which makes starting the engine easier by relieving pressure within the pump head. Unfortunately, over time components may wear out and begin to fail eventually requiring replacement to ensure your equip...Read morement runs properly. Note, this high-quality kit includes multiple parts, to ensure the correct application of these components, refer to the appropriate diagrams for your model. A wrench set will be needed to perform this repair.