020552-00 Briggs and Stratton Pressure Washer - Overview
Sections of the 020552-00
[Viewing 1 of 1]
Keep searches simple, eg. "belt" or "pump".
Kit, Engine Mounting Hardware
PartSelect #: PS8912248
Manufacturer #: 195294GS
This is an authentic replacement part that has been sourced from the original manufacturer to be used with pressure washers from Briggs & Stratton and Troy-Bilt. The hardware is used to attach the mot...
$41.95
Special Order
18oz 30w 4 Cycle Oil
PartSelect #: PS8817222
Manufacturer #: 100005
This bottle of oil can be used in over 150 different types of machinery. It is most commonly used for pressure washers and generators from manufacturers such as Briggs and Stratton and Troy-Bilt. This...
$8.95
In Stock
Thermal Relief Valve
PartSelect #: PS9270416
Manufacturer #: 208673GS
This genuine OEM sourced replacement part is designed for use with pressure washers. If the pressure washer runs too long with out the release of water from the sprayer, the water will heat up inside ...
$27.95
Special Order
Axle, 5/8"
PartSelect #: PS8904820
Manufacturer #: 191267RGS
This is a genuine replacement part sourced from the original manufacturer for use with power generators. The metal axle connects to the machine's frame structure and is used to provide a mount for the...
No Longer Available
Kit, Vibe Mount
PartSelect #: PS8910434
Manufacturer #: 192310GS
It is an authentic high quality item that is supplied from original equipment manufacturer for use with Briggs and Stratton and Troy-Bilt pressure washers. This kit attaches to the base of the pressur...
No Longer Available
Common Symptoms of the 020552-00
[Viewing 1 of 1]
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
The foward motor mounts both failed allowing the entire engine and pump to swing back
I loosened the rear motor mounts which protrude through slots in the frame using a 15mm open end allowing the engine to be moved enough to pass the front mounts through both the frame and the engine mounting holes. The upper bolts on the front mounts don't have enough clearance for a socket or box end and the open end gets less than a quarter turn at a time unless you remove the wheels. I just took my time and tightened the nuts being careful not to round the corners. The lower bolt/nuts present no problem.
Parts Used:
-
Edward from BANGOR, PA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Wrench set
1 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!