020330-0 Briggs and Stratton Pressure Washer - Overview
Sections of the 020330-0
[Viewing 1 of 1]
Keep searches simple, eg. "belt" or "pump".
Kit, Engine Mounting Hardware
PartSelect #: PS8912248
Manufacturer #: 195294GS
This is an authentic replacement part that has been sourced from the original manufacturer to be used with pressure washers from Briggs & Stratton and Troy-Bilt. The hardware is used to attach the mot...
$41.95
Special Order
18oz 30w 4 Cycle Oil
PartSelect #: PS8817222
Manufacturer #: 100005
This bottle of oil can be used in over 150 different types of machinery. It is most commonly used for pressure washers and generators from manufacturers such as Briggs and Stratton and Troy-Bilt. This...
$8.95
In Stock
Pump Saver Kit - 4oz
PartSelect #: PS9042654
Manufacturer #: 6039
This is an authentic OEM part from Briggs and Stratton, Troy-Bilt, and Snapper for use with Pressure Washers. The Briggs & Stratton Pressure Washer Pump Saver prevents harmful buildup of hard-water mi...
$21.95
Special Order
Garden Hose Filter
PartSelect #: PS9181874
Manufacturer #: B2384GS
This is a genuine OEM sourced replacement part that is intended to be used with pressure washers from Craftsman. The screen fits into the water inlet tube and is used to prevent debris from the hose f...
$8.95
Special Order
O-Ring Kit
PartSelect #: PS10000585
Manufacturer #: 705001
This item is an authentic OEM sourced O-ring kit that replaces worn or damaged O-rings for the gun, hose and wand.Unfortunately, over time o-rings will wear out and they may begin to crack eventually ...
$34.95
Special Order
Common Symptoms of the 020330-0
[Viewing 1 of 1]
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
The foward motor mounts both failed allowing the entire engine and pump to swing back
I loosened the rear motor mounts which protrude through slots in the frame using a 15mm open end allowing the engine to be moved enough to pass the front mounts through both the frame and the engine mounting holes. The upper bolts on the front mounts don't have enough clearance for a socket or box end and the open end gets less than a quarter turn at a time unless you remove the wheels. I just took my time and tightened the nuts being careful not to round the corners. The lower bolt/nuts present no problem.
Parts Used:
-
Edward from BANGOR, PA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Wrench set
1 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!