020309-04 Briggs and Stratton Pressure Washer - Overview

The engine mounting hardware kit is sold as a set that contains all the necessary parts. These are genuine items that are supplied by the original equipment manufacturer for use with pressure washers made by Briggs & Stratton, Troy-Bilt, and Snapper. A wrench set might be necessary during the installation of these parts. These items might break over time and will need replacing.

This is an authentic replacement part manufactured for use with pressure washers. The nozzle is used to provide an even spray when using soap or a chemical cleaner. This black soap nozzle is available as an individual replacement part, please see model diagram for nozzle kits for a specific model pressure washers.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Briggs and Stratton and Troy-Bilt pressure washers. The purpose of these components is to provide an air-tight seal between connected parts, please make sure to refer to the appropriate diagrams of your model for the correct location and a...Read morepplication of this hardware. Keep in mind this high-quality kit is sold individually, note that it includes six durable rubber seals.

This bottle of oil can be used in over 150 different types of machinery. It is most commonly used for pressure washers and generators from manufacturers such as Briggs and Stratton and Troy-Bilt. This detergent oil is warranty approved and specially compounded for warm weather use. Please note: it is important to avoid over filling your engine with oil.

This is a genuine OEM sourced replacement part that is intended to be used with pressure washers from Craftsman. The screen fits into the water inlet tube and is used to prevent debris from the hose from entering the pump assembly. This item is available as an individual replacement part.

This is a genuine item that is supplied directly from the original equipment manufacturer for use with Troy-Bilt and Briggs and Stratton pressure washers. It is an identical replacement for a missing or a faulty handle fastening kit that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for t...Read morehe correct location and application of these components. This high-quality kit is sold individually, keep in mind it includes two durable plastic grips and two bolts to secure them.

This is available as a set that contains four different nozzles. They are authentic OEM sourced items which are specifically produced for use with pressure washers made by Briggs & Stratton and Snapper. A set of pliers might be needed during the installation process. They are made of metal and plastic and will need to be replaced if they break.

This authentic manufacturer-sourced replacement fuel tank assembly is produced for Briggs and Stratton and Troy-Bilt pressure washers. The purpose of this part is to hold the chemical solution that is used by the unit. It is made of high-quality plastic and is sold individually, it includes the tank, the lines, and the cap. Over time it m...Read moreay wear out and begin to fail eventually requiring a replacement, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this component.

This genuine OEM sourced replacement part is designed for use with pressure washers. If the pressure washer runs too long with out the release of water from the sprayer, the water will heat up inside the pump. Once the water gets to a certain temperature the thermal valve will open and release the pressurized hot water, to protect the pum...Read morep. If this happens too often you have a greater chance of damaging your pump. This valve consists of one (1) metal and one (1) plastic piece. To complete this repair you will need a wrench.