01988-1 Briggs and Stratton Pressure Washer - Overview
Sections of the 01988-1
[Viewing 1 of 1]
Keep searches simple, eg. "belt" or "pump".
Kit, Engine Mounting Hardware
PartSelect #: PS8912248
Manufacturer #: 195294GS
This is an authentic replacement part that has been sourced from the original manufacturer to be used with pressure washers from Briggs & Stratton and Troy-Bilt. The hardware is used to attach the mot...
$41.95
Special Order
Nozzle, Qc, White
PartSelect #: PS8907533
Manufacturer #: 195983RGS
This is an original replacement part manufactured for use with pressure washers. This quick change nozzle delivers a 40-¦ angle spray for use with several pressure washing applications. The white quic...
$20.95
Special Order
Nozzle, Qc, Yellow
PartSelect #: PS8910097
Manufacturer #: 195983PGS
This is an authentic OEM part designed to fit the pressure washers listed below. This is a yellow chiseling style tip, with a standard fifteen (15) degree spray width. This nozzle is recommended for w...
$20.95
Special Order
Kit, Handle Fastening
PartSelect #: PS9181264
Manufacturer #: B2203GS
This is a genuine item that is supplied directly from the original equipment manufacturer for use with Troy-Bilt and Briggs and Stratton pressure washers. It is an identical replacement for a missing ...
$9.95
Special Order
Garden Hose Filter
PartSelect #: PS9181874
Manufacturer #: B2384GS
This is a genuine OEM sourced replacement part that is intended to be used with pressure washers from Craftsman. The screen fits into the water inlet tube and is used to prevent debris from the hose f...
$8.95
Special Order
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
The foward motor mounts both failed allowing the entire engine and pump to swing back
I loosened the rear motor mounts which protrude through slots in the frame using a 15mm open end allowing the engine to be moved enough to pass the front mounts through both the frame and the engine mounting holes. The upper bolts on the front mounts don't have enough clearance for a socket or box end and the open end gets less than a quarter turn at a time unless you remove the wheels. I just took my time and tightened the nuts being careful not to round the corners. The lower bolt/nuts present no problem.
Parts Used:
-
Edward from BANGOR, PA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Wrench set
1 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!